Moxa ioLogik W5312 [17/194] Laboratory testing

ioLogik W5300 Getting Started

2-3

Laboratory Testing

Grounding the Unit

The ioLogik is equipped with one grounding point located on the top of the device next to the Power Input

Terminal Block. To provide better stability for both power and signal transmission, we recommend wiring the

grounding point to a suitable grounded contact, such as the power supply or a cabinet enclosure.

WARNING

This equipment is intended to be used in Restrict

ed Access Locations

. External metal parts are

hot! Before touching it, special attention or protection is necessary.

Connecting to a Power Source

Connect the 12 to 36 VDC power line to the ioLogik’s Power Input Terminal Block. If power is properly supplied,

the PWR LED will glow a steady GREEN color; the READY LED will glow a steady GREEN when the system is

ready.

ATTENTION

Determine the maximum possible current for each power wire and common wire. Observe all electrical codes

dictating the maximum current allowable for each wire size. If the current exceeds the maximum rating, the

wiring could overheat, causing serious damage to your

equipment. For safety reasons, we recommend an

average cable size of 22 AWG. However, depending on the current load, you may want to adjust your cable size

(the maximum wire size for power connectors is 2 mm).

Connecting to ioAdmin via Ethernet

Configuring the Computer’s IP Address

1. For initial configuration, we recommend using a direct connection through the RJ45 Ethernet

console port to a host computer, rather than remotely over the cellular network. Connect the ioLogik to

the host PC with an Ethernet cable.

2. Set the host PC’s IP address to 192.168.127.XXX. (where XXX can range from 001 to 253). In

Windows, you can adjust this setting through the Control Panel



Network and Internet. The default

ioLogik device settings are:

Default IP Address Default Netmask Default Gateway

192.168.127.254 255.255.255.0 None