Moxa ioLogik W5312 [51/194] Attention

ioLogik W5300 The ioAdmin Utility

3-23

Current Counts allows the counter to be reset to zero so that relay triggers may be measured in batches. For

example, if RLY-0 is connected to an external relay control board, you can monitor the current counts to see

when to replace the external relay component before it fails. Last Reset Time records the last time Current

Counts was reset. Both Total Counts and Current Counts will be saved when there is a power failure. The

Last Reset Time will be saved whenever the user manually presses the Reset to Zero button.

You can control how a digital output / relay output channel acts when the network is disconnected by navigating

to the Watchdog tab in the main window panel and setting the appropriate parameters in the Safe Status

Settings and the Host Connection Watchdog panels. When the Host Connection Watchdog is enabled, a

network disconnection will activate a safe state. The DO channel can be configured to turn on, turn off, or

commence pulse output during the safe state. If the Host Connection Watchdog is not enabled, then the

DO/Relay Output channel status will remain unchanged during a network disconnection.

ATTENTION

The

Host Connection Watchdog is disabled by default and must be enabled for Safe Status Settings

take effect.

Testing DI and DO Channels

You can test each channel by opening the channel’s configuration window (by clicking on its entry in the I/O

configuration panel in the main window) and selecting the Test tab.

Digital Input Test:

Digital Ouput Test:

Use the Test panel to see how a channel’s status affects or is affected by the attached device. For DO/Relay

Output channels, you can set the on/off status or start and stop pulse output. For DI channels, you can monitor

the attached device’s on/off status, or monitor the counter.