Moxa OnCell G2111-T [21/48] Serial line settings

OnCell G2111/G2151I Series AT Command Set

3-6

Disable the Facility Lock

Disabling the facility lock will allow the OnCell G2111/G2151I Series modem to operate without entering the

PIN code each time the modem is powered up.

Type AT+CPIN=<pin> where <pin> is the correct PIN. Press Enter.

Type AT+CLCK=“SC”,0,<pin> where SC should be capitals and <pin> is the correct PIN. The following

example shows “0000” being entered for the PIN:

1. To enable the facility lock, type AT+CLCK=“SC”,1,<pin>

The following example shows “0000” being used for the PIN.

ATTENTION

Once the correct PIN is entered, the system will activate the

Automatic PIN Entry

function. This function will

store the current PIN in its memory and enter it into the OnCell G2111/G2151I Series modem each time the

system boots up. If the SIM card does not match the current PIN, the

Automatic PIN Entry

function will be

deactivated.

activate the Automatic PIN Entry function again, use the AT+ CPIN

command or OnCell Configurator to

enter the correct PIN.

To disable

Automatic PIN Entry once and for all, use the AT*USEPIN=0 command.

Serial Line Settings

ATTENTION

Changes to the serial communication parameters take effect immediately. You will need to update your

terminal settings to match any changes in the serial communication parameters.

Configuration can also be performed with the AT*SERIAL command

or OnCell Configurator.