Hitachi CL 14 DSL Инструкция по эксплуатации онлайн [28/34] 167

-26-

(i) Mounting the Cover [34] or the Cutter Ass'y M8 [47]

Remove the Battery [8] and fasten the Cover [34] with the two Machine Screws

(W/Washers) M4 x 20 (Black) [33]. The Cutter Ass'y M8 [47] must be mounted in the proper

direction. As shown in Fig. 32, it must be mounted so that if the groove in the side of one cutter

is present (Yes), the groove in the side of the outer cutter is not present (No). After mounting

direction has been confirmed, fasten the cutters with the two Special Bolts M5 x 9 [45].

(j) Fasten the Stud Guide Ass'y [42] with the Bolt W3/8 x 75 [44] and the Spring Washer M10

[43] as shown in Fig. 9.

(k) Tightening torques are as follows:

Tapping Screw (W/Flange) D4 x 20 (Black) [4]

1.96±0.49 N

•m (20±5 kgf•cm, 17.4±4.3 in-lbs.)

Machine Screw (W/Washers) M4 x 20 (Black) [33]

1.76±0.49 N

•m (18±5 kgf•cm, 15.7±4.3 in-lbs.)

Seal Lock Screw (W/SP. Washer) M4 x 12 [36]

1.76±0.49 N

•m (18±5 kgf•cm, 15.7±4.3 in-lbs.)

Tapping Screw (W/Flange) D5 x 25 (Black) [13]

3.43±0.49 N

•m (35±5 kgf•cm, 30.5±4.3 in-lbs.)

Tapping Screw D5 x 35 [39] 3.43±0.49 N

•m (35±5 kgf•cm, 30.5±4.3 in-lbs.)

Hex. Socket Hd. Bolt (W/Flange) M5 x 12 [30]

5.88±1.47 N

•m (60±5 kgf•cm, 52.2±13 in-lbs.)

Special Bolt M5 x 9 [45] 5.88±1.47 N

•m (60±15 kgf•cm, 52.2±13 in-lbs.)

Lock Nut M12 [41] 34.3±7.35 N

•m (350±75 kgf•cm, 304.5±65 in-lbs.)

Bolt W3/8 x 75 [44] 15.68±3.92 N

•m (160±40 kgf•cm, 139.2±35 in-lbs.)

8-3. Precautions in Disassembly and Reassembly of Battery Charger

Refer to the Technical Data and Service Manual for precautions in disassembly and reassembly

of the Model UC 18YRSL battery charger.