Home
Главная
Makita
Отбойные Молотки
HM 1304
Инструкция по эксплуатации Страница: 6

Makita HM 1304 [6/20] Accessories

MAINTENANCE

CAUTION:

Always be sure that the tool is switched off and

unplugged before attempting to perform inspection or

maintenance.

Replacing carbon brushes (Fig. 5, 6 & 7)

When the resin insulating tip inside the carbon brush is

exposed to contact the commutator, it will automatically

shut off the motor. When this occurs, both carbon

brushes should be replaced. Keep the carbon brushes

clean and free to slip in the holders. Both carbon brushes

should be replaced at the same time. Use only identical

carbon brushes.

• Use a screwdriver to remove the holder cap plates.

• Use a screwdriver to remove the brush holder caps.

Take out the worn carbon brushes, insert the new ones

and secure the brush holder caps.

• Reinstall the holder cap plates firmly.

Lubrication (Fig. 8 & 9)

This tool requires no hourly or daily lubrication because it

has a grease-packed lubrication system. It should be

relubricated after every 6 months of operation. Send the

complete tool to Makita Authorized or Factory Service

Center for this lubrication service. However, if circum-

stances require that you should lubricate it by yourself,

proceed as follows.

• Run the tool for several minutes to warm it up. Switch

off and unplug the tool.

• Remove the crank cap using a hex wrench, then

replenish with fresh grease (60 g). Use only Makita

genuine hammer grease (optional accessory). Filling

with more than the specified amount of grease

(approx. 60 g) can cause faulty hammering action or

tool failure. Fill only with the specified amount of

grease.

• Reinstall the crank cap securely with the hex wrench.

To maintain product SAFETY and RELIABILITY, repairs,

any other maintenance or adjustment should be per-

formed by Makita Authorized Service Centers, always

using Makita replacement parts

ACCESSORIES

CAUTION:

These accessories or attachments are recommended for

use with your Makita tool specified in this manual. The

use of any other accessories or attachments might

present a risk of injury to persons. Only use accessory or

attachment for its stated purpose.

If you need any assistance for more details regarding

these accessories, ask your local Makita service center.

• Bull point

• Cold chisel

• Scaling chisel

• Clay spade

•Rammer

• Hammer grease

• Steel carrying case

EC-DECLARATION OF CONFORMITY

We declare under our sole responsibility that this product

is in compliance with the following standards or standard-

ized documents,

HD400, EN50144, EN55014, EN61000

in accordance with Council Directives, 73/23/EEC,

89/336/EEC and 98/37/EC.

Measured sound power level: 100 dB

Guaranteed sound power level: 103 dB

These sound power levels were measured in accordance

with Council Directive, 2000/14/EC.

Conformity assessment procedure: Annex VI

Notified Body: BSI Product Services, Maylands Avenue,

Hemel Hempstead HP2 4SQ, England.

Vibration

The typical weighted root mean square acceleration

value is 13 m/s

Yasuhiko Kanzaki

CE 2002

Director

MAKITA INTERNATIONAL EUROPE LTD.

Michigan Drive, Tongwell, Milton Keynes,

Bucks MK15 8JD, ENGLAND

Makita HM 1304 [6/20] Accessories

Содержание

Похожие устройства