AEG EWH 10 mini [9/24] Electrical connection 2

For the fitter

English

9

Never connect the storage water heater to the electrical power supply without first checking

whether the storage water heater is actually filled with water.

2.3 Electrical connection 2

1 Connection panel

2 Temperature limiter

3 Thermostat

and the relevant standards and regulations into consideration. It is particularly important to observe the

“Regulations for installing high-voltage systems with rated voltages up to 1000 V” and regulations from

the local power supply company.

The appliance must be connected to a socket outlet with earthing contact – this socket outlet must

be freely accessible after installation of the appliance. If the appliance is to be connected to the AC

network (appliance outlet socket), an air gap of at least 3 mm must be provided to allow the appliance

to be disconnected from the power supply.

Installation using a permanently installed connecting cable is not permitted.

2.4 Putting into operation

The specialist technician must monitor the appliance when it is put into operation and heats water for

unused for a relatively long period of time. Heat loss is minimised by the high-quality heat-insulation

material. The storage water heater must be drained if there is a risk of exposure to subzero temperatures.

2.5 Maintenance

The outside of the storage water heater does not require any special maintenance. To clean, wipe using a

soft cloth or damp sponge only. Do not use any abrasive agents or aggressive detergents.

Caution! Always fully disconnect the appliance from the power supply before carrying out any

maintenance work.

To ensure a long service life, it is recommended to have a specialist technician inspect the anti-corrosion

anode (magnesium anode) in the appliance once per year. This check may need to be carried out more

frequently in areas with particularly aggressive water – ask the fitter or your local water supply company

Draw-off the temperature-knob, loose the screw, pull the lower casing part to the front and demount.

EWH mini U / mini U NEWH mini / mini N