Liebherr ICBN 3376 [5/18] Switching on the entire appliance at the freezer compartment

Liebherr ICBN 3376 [5/18] Switching on the entire appliance at the freezer compartment
3.2 Temperature display
During normal operation, the display shows:
-
the highest freezing temperature
-
the average cooling temperature
The freezer temperature display flashes if/when:
-
You change the temperature setting
-
The appliance is not cold enough after switching on
-
The temperature rises by several degrees
Stripes flash in the display if/when:
-
The freezer temperature exceeds 0 °C.
The following displays indicate a fault. Possible causes and
solutions: (see Malfunction).
-
F0 to F9
-
FE*
-
The power failure symbol flashes.
4 Putting into operation
4.1 Switching on the appliance
Note
The manufacturer recommends:
u
Store frozen produce at -18 °C or colder.
Switch on the appliance approx. 2 hours before loading for the
first time.
4.1.1 Switching on the entire appliance at the
freezer compartment
u
Open the door.
u
Press On/Off button, freezer compartment
Fig. 2 (8)
.
w
The temperature display of the refrigerator compartment
indicates the current temperature inside.
w
The temperature display of the freezer compartment and the
alarm symbol flash until the temperature is sufficiently low. If
the temperature is above 0 °C, dashes flash. If it is below,
the current temperature flashes.
4.1.2 Switching on refrigerator and
BioFresh compartment
Note
Before going on holiday, or other prolonged periods of non-use
u
You can switch the fridge section on/off separately from the
freezer section.
u
Open the door.
u
Press On/Off button, refrigerator compartment
Fig. 2 (1)
.
w
The fridge and BioFresh section are on: Fridge temperature
display
Fig. 2 (2)
is on. When you open the door the interior
light comes on.
5 Control
5.1 Child proofing
The child-proofing function enables you to make
sure that the appliance is not inadvertently switched
off by playing children.
5.1.1 Setting the child lock function
u
To activate the setting mode: press SuperFrost button
Fig. 2 (12)
for about 5 s.
w
c flashes on the display.
w
The menu symbol
Fig. 2 (16)
shines.
u
Briefly press the SuperFrost button
Fig. 2 (12)
.to confirm.
When c1 is indicated in the display:
u
Tto activate the child lock, briefly press the
SuperFrost button
Fig. 2 (12)
.
w
The child lock symbol
Fig. 2 (17)
shines. c flashes in the
display.
When c0 is indicated in the display:
u
to deactivate the child lock, briefly press the SuperFrost
button
Fig. 2 (12)
.
w
The child lock symbol
Fig. 2 (17)
goes out. c flashes in the
display.
u
To deactivate the set-up mode: press On/Off button, freezer
compartment
Fig. 2 (8)
.
-or-
u
Wait for 5 minutes.
w
The temperature is indicated again in the temperature
display.
5.2 Door alarm
For the fridge, BioFresh and freezer compartments
An audible warning sounds if the door is open for
longer than 60 seconds.
The audible warning stops automatically when the
door is closed.
5.2.1 Muting the door alarm
The audible alarm can be muted when the door is open. The
sound switch-off function is active as long as the door is left
open.
u
Press alarm button
Fig. 2 (14)
.
w
The door alarm is silenced.
5.3 Temperature alarm
The audible alarm sounds if the freezer temperature
is not cold enough.
The temperature display and the alarm symbol
Fig. 2 (15)
flash at the same time.
The cause of the temperature being too high may be:
-
warm fresh food was placed inside
-
too much warm ambient air flowed in when rearranging and
removing food
-
power failure for some time
-
the appliance is faulty
The audible alarm is automatically silenced, the alarm symbol
Fig. 2 (15)
goes out and the temperature display stops flashing
when the temperature is sufficiently cold again.
If the alarm status persists: (see Malfunction).
Note
Food may be spoilt if the temperature is not cold enough.
u
Check the quality of the food. Do not consume spoiled food.
5.3.1 Muting the temperature alarm
The audible alarm can be muted. When the temperature is
sufficiently cold again, the alarm function is active again.
u
Press alarm button
Fig. 2 (14)
.
Putting into operation
* Depending on model and options 5

Содержание

Похожие устройства

Скачать
Случайные обсуждения

Ответы 1

Каково назначение прибора?
1 год назад