Janome JEM PLATINUM 760 [8/46] Function buttons
Превью страниц
Страница 8 /
46
![Janome JEM PLATINUM 760 [8/46] Function buttons](/views2/1341707/page8/bg8.png)
6
e Auto-lock button
When stitch pattern #01, #05 or #10 has
been selected, the machine will immediately sew
locking stitches and automatically stop when the
auto-lock button is pressed.
When sewing any other stitches, the machine will
sew locking stitches at the end of the pattern being
sewn and automatically stop.
w Reverse button
When sewing the stitch pattern #01, #05 or #10
the machine will sew in reverse as long as the
reverse button is pressed.
If you press the reverse button when sewing any
other stitches, the machine will immediately sew
locking stitches and automatically stop.
If you press the reverse button when stitch pattern
#01, #05 or #10 has been selected and the
foot control is not connected, the machine will start
sewing in reverse as long as the button is pressed
and the machine will stop when the button is
released.
r Up/down needle button
Press this button to bring the needle up or down.
The machine will stop with the needle up or down
depending on the needle position determined by this
button.
q Start/stop button
Press this button to start or to stop the machine.
The machine will run slowly as long as this button is
pressed, and will start running at the speed set by the
speed control lever, or stop when the button is
released.
NOTE:
The start/stop button does not work when the foot
control is connected.
r
e
w
q
Function Buttons
Содержание
62- Warnin
- The design and specifications are subject to change without a prior notice
- Important safety instructions
- Save these instructions
- Know your machine
- Setting the spool pin
- Name of parts
- Standard accessories
- Extention table
- Warning
- Getting ready to sew
- Connecting the power supply
- Controlling sewing speed
- Function buttons
- Warning
- Dropping the feed dog
- Detaching and attaching the foot holder
- Changing the presser foot
- Raising and lowering the presser foot
- Balancing thread tension
- Needle and thread chart
- Changing needles
- Always make sure to turn the power switch off and disconnect the machine from power supply before changing the needle
- Z loosen the needle clamp screw by turning it counterclockwise remove the needle from the clamp q needle clamp screw
- X insert a new needle into the needle clamp with the flat side of the needle to the rear when inserting the needle into the needle clamp push it up against the stopper pin and tighten the needle clamp screw firmly w stopper pin e flat side
- Warning
- To check needle straightness place the flat side of the needle onto something flat a needle plate glass etc the gap between the needle and the flat surface should be consistent never use a blunt needle r gap
- Raise the needle by turning the handwheel and lower the presser foot turn off the power switch
- Winding the bobbin
- Warning
- Threading the machine
- Needle threader
- Drawing up the bobbin thread
- Straight stitch
- Basic stitches
- Variety of straight stitches and recommended feet
- Zigzag stitch
- Overcasting with zigzag stitch
- Multiple zigzag stitch tricot stitch
- Utility stitches
- Buttonholes
- Button sewing
- Zipper sewing
- Caution
- Blind hemming
- Eyelet
- Patchwork
- Decorative sewing
- Applique
- Smocking
- Scallop stitch
- Decorative satin stitches
- Fagoting
- Cross stitch
- Correcting distorted stretch patterns
- Pattern combination
- Warning
- Replacing the bobbin holder
- Cleaning the hook race and feed dogs
- Care and maintenance
- Problems and warning signals
- Troubleshooting
Похожие устройства
-
Janome TOP 14Инструкция к устройству -
Janome TOP 12Руководство по использованию -
Janome ESCAPE V-17Руководство по эксплуатации -
Janome S-21Инструкция по работе -
Janome LADY 725Руководство по настройке -
Janome S-19Руководство по эксплуатации -
Janome ARTDECOR 724EРуководство по эксплуатации -
Janome ARTDECOR 724AРуководство по эксплуатации -
Janome LEGEND LE-35Руководство по эксплуатации -
Janome ARTDECOR 718AРуководство по эксплуатации -
Janome S-17Руководство по эксплуатации -
Janome LW 20Инструкция по эксплуатации