McCulloch 22 LCS [10/618] Assembling the cutting equipment

McCulloch 22 LCS [10/618] Assembling the cutting equipment
ASSEMBLY
10 – English
Fitting the loop handle
Clip the loop handle onto the shaft. Note that the loop
handle must be fitted between the arrows on the shaft.
Fit the bolt, securing plate and wing nut as shown in
the diagram. Tighten the wing nut.
Assembling and dismantling the
two-piece shaft
Assembly:
Loosen the coupling by turning the knob.
Align the tab of the attachment (A) with the hole in the
coupling (B).
Push the attachment into the coupling until the
attachment snaps into place.
Before using the unit, tighten the knob securely.
Dismantling:
Loosen the coupling by turning the knob (at least 3
times).
Push and hold the button (C). While securely holding
the engine end, pull the attachment straight out of the
coupling.
Assembling the cutting
equipment
A
B
!
WARNING! Never use a cutting
attachment without an approved guard.
See the chapter on Technical data. If an
incorrect or faulty guard is fitted this can
cause serious personal injury.
C

Содержание

ASSEMBLY Fitting the loop handle no Clip the loop handle onto the shaft Note that the loop handle must be fitted between the arrows on the shaft Loosen the coupling by turning the knob at least 3 times Fit the bolt securing plate and wing nut as shown in the diagram Tighten the wing nut Assembling and dismantling the two piece shaft Assembly Push and hold the button C While securely holding the engine end pull the attachment straight out of the coupling Assembling the cutting equipment Align the tab of the attachment A with the hole in the coupling B Push the attachment into the coupling until the attachment snaps into place 10 English WARNING Never use a cutting attachment without an approved guard See the chapter on Technical data If an Incorrect or faulty guard is fitted this can cause serious personal injury

Скачать