Ariens ST28DLET PRO TRACK [24/38] Handlebar height

Ariens ST28DLET PRO HYDRO TRACK [24/38] Handlebar height
EN - 24
HANDLEBAR HEIGHT
(Figure 21)
To raise or lower the handlebar:
1. Place unit in service position (see
Service Position on page 20).
2. Remove bottom cover.
3. Remove top mounting bolts from the
handlebars and adjust the handlebar up
or down as needed until the handlebar
mounting holes align with holes in unit
frame.
4. Secure handlebar to frame with
hardware removed in step 3 using the
different hardware locations shown in
Figure 21.
5. Check and adjust speed selector. See
Speed Selector Adjustment on page 25.
6. Check tension on auger and traction
clutch cables.
IMPORTANT: Cables should not be slack nor
under tension. Adjust as necessary.
7. Re-install bottom cover.
REMOTE DEFLECTOR CONTROL
(Figure 22)
Deflector must stay in selected position while
throwing snow.
If deflector does not stay in set position:
1. Tighten nut beneath control panel to
increase pressure on deflector control.
If deflector does not follow full range of travel:
1. Push deflector remote all the way
forward.
2. Loosen adjusting nuts on cable support
bracket underneath the dash panel
(Figure 22).
3. To adjust the deflector lower:
Slide cable down. Tighten bottom nut.
4. To adjust deflector higher:
Slide cable up. Tighten top nut.
5. Check travel and repeat adjustment as
necessary.
CAUTION: AVOID INJURY. Adjust
the attachment clutch, speed
selector and traction clutch after
changing the handlebar height. See
Attachment Clutch/Brake
Adjustment on page 25 and Speed
Selector Adjustment on page 25.
Figure 21
1. Upper Position
2. Lower Position
3. Handlebar
4. Upper Mounting Bolt
5. Lower Mounting Bolt
1
2
3
4
3
5
5
4
1
2
OS7155
Figure 22
2
1
1. Adjusting Nuts
2. Cable Support Bracket

Содержание

Скачать