Yaskawa CIMR-UU4A0240A [52/644] Horizontal suspension of drive models 2 o 0154 to 2 o 0248 and 4 o 0156 to 4 o 0414
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Yaskawa CIMR-UU4A0240A [52/644] Horizontal suspension of drive models 2 o 0154 to 2 o 0248 and 4 o 0156 to 4 o 0414

Yaskawa CIMR-UU4A0302F [52/644] Horizontal suspension of drive models 2 o 0154 to 2 o 0248 and 4 o 0156 to 4 o 0414
n
Horizontal Suspension of Drive Models 2o0154 to 2o0248 and 4o0156 to 4o0414
To make a wire hanger or frame for use when lifting the drive with a crane, lay the drive in a horizontal position and pass a
wire through the hanging brackets.
NOTICE: Use the hanging
brackets on the top and hanging holes of the bottom cover when lifting models 2
o
0154F, 2
o
0192F, 4
o
0156F,
and 4
o
0180F.
2□0154A, 2□0192A, 2□0248,
4□0156A, 4□0180A, and 4□0216 to 4□0414
2□0154F, 2□0192F, 4□0156F, and 4□0180F
Figure 2.4 Horizontal Suspension (Models 2o0154 to 2o0248 and 4o0156 to 4o0414)
n
Vertical Suspension of the Drive
Follow the procedure described below when suspending the drive with eye bolts or hanging brackets.
Models 2
o
0028 to 2
o
0130 and 4
o
0011 to 4
o
0124
WARNING! Crush Hazard. Use an adequate length of wire to ensure a 50° or wider suspension angle as illustrated in Figure 2.5. The
maximum allowable load of the eye bolts cannot be guaranteed when the drive is suspended with the wires at angles less than 50°. Failure
to comply may result in serious injury or death from falling equipment.
1. Pass wire through the holes of the two eye bolts.
Suspending angle:
50° or greater
Figure 2.5 Drive Suspension Using Wires and Eye Bolts
(Models 2o0028 to 2o0130 and 4o0011 to 4o0124)
2. Gradually take up the slack in the wires and hoist the drive after the wires are stretched tight.
2.2 Mechanical Installation
52
YASKAWA ELECTRIC SIEP C710636 04C U1000 Industrial MATRIX Drive Technical Manual

Содержание

Похожие устройства

Скачать