Home
Главная
Ridgid
КЛЕЩИ
37428
Инструкция по эксплуатации Страница: 10

Ridgid 37428 [10/427] Changing installing batteries

On Product Icons

This equipment is used to make electrical measurements. Incorrect use or im-

proper application may result in incorrect or inaccurate measurements. Selection of ap-

propriate measurement methods for the conditions is the responsibility of the user.

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digi-

tal device, pursuant to part 15 of the FCC Rules. These limits are designed to provide rea-

sonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not in-

stalled and used in accordance with the instructions, may cause harmful interference to

radio communications.

However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Consult the dealer or an experienced radio/TV technician for help.

Electromagnetic Compatibility (EMC)

The term electromagnetic compatibility is taken to mean the capability of the product to

function smoothly in an environment where electromagnetic radiation and electrostatic

discharges are present and without causing electromagnetic interference to other equip-

ment.

The RIDGID micro CM-100 Digital Clamp Meter conforms to all applicable

EMC standards. However, the possibility of it causing interference in other devices can-

not be precluded.

Changing/Installing Batteries

The RIDGID micro CM-100 Digital Clamp Meter is supplied without the battery installed.

When the low battery [ ] icon appears on the display screen, replace the battery. Op-

erating the clamp meter with a low battery can cause incorrect readings. Remove the bat-

tery prior to long-term storage to avoid battery leakage.

1. Switch OFF the device and disconnect test leads.

micro CM-100 Digital Clamp Meter

ouble Insulation Symbol

Earth Ground Symbol 9V Battery Symbol

CAT III IEC Overvoltage Category III CAT II IEC Overvoltage Category II

CAT III equipment is designed to protect CAT II equipment is designed to protect

against transients in equipment in fixed against transients from energy-

equipment installations, such as consuming equipment supplied from

distribution panels, feeders and short the fixed installation, such as TVs, PCs

branch circuits, and lighting systems portable tools, and other household

in large buildings. appliances.

Do not dispose of electrical equipment

Conforms to European Union directives. with household waste!

NOTICE

Ridgid 37428 [10/427] Changing installing batteries

Содержание

Похожие устройства