Ricoh Aficio SP 9100DN Инструкция по эксплуатации онлайн [214/344] 58838

Access type Type of access permission

read read only

write read and write

trap user is notified of trapmessages

Protocol configuration

msh> snmp {ipv4|ipv6|ipx} {on|off}

• Use the following command to set protocols "active" or "inactive": If you set a protocol "inactive",

all access settings for that protocol are disabled.

• Specify "ipv4" for IPv4, "ipv6" for IPv6, or "ipx" for IPX/SPX.

• {on} means "active" and {off} means "inactive".

• All protocols cannot be turned off concurrently.

Configuration of protocol for each registration number

msh> snmp "number" active {ipv4|ipv6|ipx} {on|off}

• To change the protocol of access settings, use the following command. However, if you have

disabled a protocol with the above command, activating it here has no effect.

Access configuration

msh> snmp "number" {ipv4|ipv6|ipx} "address"

• You can configure a host address according to the protocol used.

• The network interface board accepts requests only from hosts that have IPv4, IPv6, and IPX

addresses with access types of "read-only" or "read-write". Enter "0" to have network interface

board accept requests from any host without requiring a specific type of access.

• Enter a host address to deliver "trap" access type information to.

• To specify IPv4 or IPv6, enter "ipv4" or "ipv6" followed by a space, and then the IPv4 or IPv6

address.

• To specify IPX/SPX, enter "ipx" followed by a space, the IPX address followed by a decimal,

and then the MAC address of the network interface board.

sysLocation configuration

msh> snmp location

Deleting sysLocation

msh> snmp clear location

sysContact setting

msh> snmp contact

Deleting sysContact

5. Monitoring and Configuring the Printer

212