Cecotec Conga 4490 [17/85] Before use
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Cecotec Conga 4490 [17/85] Before use

Cecotec Conga 4490 [17/85] Before use
3332
ENGLISH ENGLISH
Wet & dry and dust tank installation
Recommendation: It is not suggested to use the scrubbing function for the first-time use.
Open the tank’s blue silicone lid, fill the tank with water carefully so water does not come out
and close it again. Make sure the silicone clip is properly closed to avoid water from pilling.
Fig.11.
Install the tank in the robot following the indicated direction. Make sure the clip is properly
fastened.
Fig.12.
Only for Wet & dry tank installation:
Attach the mop to the bottom part of the mop bracket with the Velcro.
Fig.13.
Manually press the clips on both sides of the Wet & dry tank and push it into its correct position.
You will hear a click when it is properly fixed.
Fig.14.
Recommendations:
Do not use the scrubbing function while the robot is unattended.
Remove the Wet & dry tank when the robot is charging or not in use.
If there are carpets in the house, set Restricted Areas to avoid the robot from passing over
them.
Add some drops of cleaning agent (not corrosive) if considered necessary.
To remove the mop bracket, press the release button and pull from it outwards.
Warnings:
Using cleaning agents in excess might block water outlets.
In order to achieve perfect scrubbing, it is suggested to moisten the mop before using it.
First cleaning
Once the robot and the charging base are completely installed, follow these steps before
scheduling the first cleaning cycle.
First of all, the robot must be fully charged. It is suggested to allow the robot to charge
overnight. When it is fully charged, it may carry out the first cleaning cycle and save the first
map. To do so, activate Auto cleaning mode and Eco power level. It is very important to follow
these indications for the robot to recognize each and every corner in the house and to create
a complete map.
If the house where the robot is going to be used is too big and the robot runs out of battery, do
not worry. The robot features TotalSurface 2.0 technology, so when it returns to the charging
base, it saves the full map and those that have not been completed. Once it is charged again,
it resumes the cleaning cycle from the point it has stopped until it maps the whole surface.
The robot keeps on mapping constantly, therefore it adapts independently to each house’s
features and continuously improves previous maps.
2. Mop bracket
3. Velcro
4. Tab
3. BEFORE USE
Take the product out of the box and remove all packaging materials.
Make sure all parts and components are included and in good conditions. If any sign of visible
damage is observed, contact immediately with the official Technical Support Service of Cecotec.
4. INSTALLATION
Robot and charging base installation
Fig.8.
Connect the charging base to a power supply and store the remaining cable. It is important to
store the remaining cable at the bottom of the charging base to avoid it from being dragged
and disconnected.
Place the charging base against the wall, leaving the safety distance indicated in the below
picture.
Note: Ensure a space of at least 1 m on both the left and right side of the charging base, and a
space of at least 2 m in front of it.
Fig.9.
Warning: Do not expose the charging base to direct sun light.
Long press the power button for 3 seconds; when the light indicator turns on, place the robot
on the charging base.
Fig.10.
Steady blue light: ON/operating
Oscillating orange light: Charging
Red light blinks: Error
Notes:
Take the robot to the charging base if the battery is low. The robot might not turn on if the
battery is very low.
The robot will automatically turn on when placed on the charging base.
The robot cannot be turned off during charging.

Содержание

Похожие устройства

Скачать