Cecotec Conga 4490 [18/85] Operation

3534

ENGLISH ENGLISH

4. Clock

5. Manual control

6. On/Pause

7. Edge mode

Remote control binding

If the robot does not respond to the remote control, follow the below steps:

Press the edge mode button on the remote control for 5 seconds for the remote control to

enter pairing mode. The screen will display 8888.

The remote receiver will be activated in 5 seconds and will enter pairing mode. The

remote control’s signal is received and the remote control returns to normal status. The

display will show pairing is completed.

If the pairing process is unsuccessful, the remote control will display 8888 and will exit the

pairing mode after 30 seconds.

The following modes and operations can be activated from the remote control.

Modes

The first time the robot is operated, it will map and save the whole house’s map by means of its

laser before starting the cleaning cycle. Use the robot in Auto mode and Eco power level, this

way you will ensure the robot memorizes the full map.

Note: Make sure the light indicator is lighted in blue before starting cleaning, indicating it is

activated. If not, press any button on the remote control to wake it up.

Auto mode

Fig.17.

Press the power button on the robot for it to start cleaning automatically, first a cleaning cycle

in Edge mode and then another cycle in and organized zigzag motion, recognizing which areas

it has cleaned and which ones it has not. The robot will automatically plan the cleaning route

as it is cleaning. If during this mode the robot is controlled manually, the robot will calculate

the route again and could go through previously cleaned areas. In order to ensure efficient

cleaning, do not operate it manually during auto mode cleaning.

Thanks to its Total Surface 2.0 technology, if the battery is low during the cleaning cycle, the

robot will smartly return to the charging base automatically and, once it is fully charged, it will

resume the cleaning process from the same point, offering a high-efficiency cleaning. During

cleaning, the robot will stop briefly to evaluate the area and calculate the cleaning route (this

stop will vary depending on the house conditions).

Note: The robot cleans in an organized way and per 4x4 m squared areas, therefore it might

leave the room where it is cleaning to finish off the delimited area. Do not worry, the robot will

clean all the accessible surface.

5. OPERATION

Once the robot’s light indicator changes from oscillating orange to steady blue, the battery is

fully charged and the robot is ready to operate.

The robot cannot operate with low battery.

Recommendations: Remove all cables and obstacles from the floor before operating the robot

in order to avoid accidents and damage.

5.1. Robot buttons

Fig.15.