Planet IPX-1800N [24/68] Planet ip pbx user s manual

PLANET IP PBX user’s manual

settings.

Restart IP PBX

Configuration

Click RESTART, and the IP PBX Service will restart completely.

Currently active calls will be disconnected immediately. This

function is rarely required unless the network setting has been

changed, or the service operates abnormally without

problematic configuration could be identified.

Revert IP PBX

Configuration

Click REVERT, and IP PBX will erase current IP PBX settings

and revert configuration back to the factory default. Note the

reversion affects IP PBX service only, but not other system

services such as DHCP, TFTP, and NTP. The backup IP PBX

configuration files under TFTP remain intact after reversion, so

that one can restore to a specific time if a backup file had been

generated then.

To revert the whole system back to the factory default as much as possible, hold the hardware Reset

button for 10 seconds. Since this will wipe out almost everything generated by the user, all system

interfaces and services must be configured from scratch again if no appropriate backup configuration

could be restored. Note that such reversion will not erase backup configurations and existing

voicemails. Backup configuration files could be deleted in the TFTP Service page and voicemails

could be deleted in the Maintenance page.

3.6.7 Advance

Select Service -> IP PBX Service, and then click the Advance tab to configure IP PBX parameters.

After the configuration, go to Service -> IP PBX Service, and click RESTART to activate changes.