Icom IC-W32A [26/48] Memory call programming

Icom IC-W32A [26/48] Memory call programming
MEMORY/CALL PROGRAMMING
6
22
General
The transceiver has 100 memory channels (plus 5 pairs of
scan edge channels) and 1 call channel on each band for
storage of often-used frequencies.
Avionics band frequencies are stored in the VHF memory
channels (U.S.A. and Asia versions only).
D Memory/call channel contents
The following information can be programmed into memory/
call channels:
Operating frequency
8-digit memory name*
1
Duplex direction (DUP or DUP) with an offset frequency
(pgs. 19, 20)
Subaudible tone encoder or tone squelch ON/OFF (pgs. 19,
32)
Subaudible tone and tone squelch frequencies (pgs. 20, 32)
Skip information*
2
(p. 30)
*
1
Except for call channels.
*
2
Except for the scan edge memory channels.
Programming during selection
q Assign the main band to the desired display with [MAIN].
w Select VFO mode with [VFO].
e Set the desired frequency:
Set the frequency using the keypad or [DIAL].
Set other data (e.g. offset frequency, duplex direction,
subaudible tone frequency, etc.), if required.
r Push [S.MW] momentarily to indicate memory channels.
Do not hold [S.MW] for more than 0.5 sec., otherwise the mem-
ory channel will overwrite the displayed number.
t Rotate [DIAL] to select the desired channel.
Call channel (CAL) and scan edge channels (1A5B), as well as
regular memory channels, can be programmed in this way.
y Push [(S.MW)MW] for 2 sec. to program.
TSQL
DUP
MAIN MAIN
momentarily
Set frequency and other data.
S.MW
[EXAMPLE]: Memory programming of ch 40 during selection.

Содержание

Скачать