![Icom IC-F121S [6/20] I programmable function keys](/img/pdf.png)
Icom IC-F121S [6/20] I programmable function keys
![Icom IC-F221S [6/20] I programmable function keys](/views2/1074519/page6/bg6.png)
3
1
PANEL DESCRIPTION
■ Programmable function keys
The following functions can be assigned to [P0], [P1], [P2]
and [P3] programmable function keys.
Consult your Icom Dealer or System operator for details con-
cerning your transceiver’s programming.
In the following explanations, programmable function names
are bracketed. The specific switch used to activate the func-
tion depends on programming.
¡¡
CH UP AND DOWN KEYS
Select an operating channel.
¡¡
BANK KEY
Select and determine a bank number.
¡¡
SCAN START/STOP KEY
Push this key to start scanning; and push again
to stop.
NOTE: Place the microphone on hook to start
scanning.
Take the microphone off hook to stop scanning.
CH UP
CH DN
BANK
¡¡
SCAN TAG KEY
Adds or deletes the selected channel to the scan
group.
¡¡
PRIORITY CHANNEL KEYS
Push these keys to select priority A or priority B
channel, respectively.
¡¡
OPERATING CHANNEL KEYS
Select an operating channel directly.
¡¡
LOCK KEY
Push this key for 1 sec. to lock all programmable
keys except the following:
• [
CALL
] (incl. [CAL A] and [CAL B]), [
MONI
]
and [
EMER
] keys.
PRI A
PRI B
CH1
CH2
CH3
CH4
TAG
SCAN A
SCAN B
LOCK
IC-F111S_F121S_F211S_F221S 02.10.3 11:54 AM Page 3 (1,1)
Содержание
- Caution neve 2
- Explicit definitions 2
- Important 2
- Precaution 2
- R warning neve 2
- Read all instruction 2
- Save this instruction manual 2
- Operating the transceiver without running the vehi cle s engine the vehicle s battery will quickly run out if the transceiver is in transmission while the vehicle s engine off 3
- Placing the transceiver against walls this will obstruct heat dissipation 3
- Placing the transceiver in excessively dusty envi ronments 3
- Table of contents 3
- The supplied microphone only other microphones have different pin assignments and may damage the trans ceiver 3
- The use of chemical agents such as benzine or alco hol when cleaning as they damage the transceiver surfaces 3
- Use or place the transceiver in areas with tempera tures below 22 f 30 c or above 140 f 60 c or in areas subject to direct sunlight such as the dashboard of a vehicle 3
- I front panel 4
- Panel description 4
- I function led 5
- Panel description 5
- I programmable function keys 6
- Panel description 6
- Panel description 7
- Panel description 8
- I channel selection 9
- I turning power on 9
- Operation 9
- D transmitting notes 10
- I receiving and transmitting 10
- Important 10
- Operation 10
- D scrambler function 11
- D user set mode 11
- Operation 11
- Connection and maintenance 12
- I rear panel and connection 12
- Connection and maintenance 13
- E dc power receptacle connects to a 12 v dc battery pay attention to polarities never connect to a 24 v battery this could damage the transceiver 13
- I supplied accessories 13
- Q antenna connector connects to an antenna ask your dealer about antenna selection and placement 13
- R optional cable opc 617 connect an external modem unit dimmer control etc 13
- T external speaker jack connect a 4 8 ω external speaker if desired 13
- W microphone hanger connect the supplied microphone hanger to the vehicle s ground for microphone on off hook functions see p 1 13
- Connection and maintenance 14
- I mounting the transceiver 14
- I optional ut 108 installation 14
- Connection and maintenance 15
- I optional opc 617 installation 15
- I optional ut 109 ut 110 installation 15
- Install the opc 617 as shown below 15
- Q turn the power off then disconnect the dc power cable w unscrew the 4 screws then remove the bottom cover e cut the pattern on the pcb at the tx mic circuit mic and rx af circuit disc as shown below r install the scrambler unit as described in optional ut 108 installation in the page at left t return the bottom cover and screws to the original posi tion 15
- Connection and maintenance 16
- I antenna 16
- I cleaning 16
- I fuse replacement 16
- Options 17
- Electromagnetic interference compatibility 18
- Safety training information 18
- 1 32 kamiminami hirano ku osaka 547 0003 japan 20
- Count on us 20
Похожие устройства
- Ardo TLE 6640 G6 X Инструкция по эксплуатации
- Tokina AT-X 12-24 II F/4 Инструкция по эксплуатации
- Icom IC-F221S Инструкция по эксплуатации
- Ardo KTLE 6640 G6 Инструкция по эксплуатации
- Tokina AT-X 10-17 F/3.5-4.5 Инструкция по эксплуатации
- Icom IC-F310 Инструкция по эксплуатации
- Ardo KA 540 G6 Инструкция по эксплуатации
- Fujifilm F XF60MMF2.4R Macro Инструкция по эксплуатации
- Icom IC-F320 Инструкция по эксплуатации
- Ardo KC 640 G6 Инструкция по эксплуатации
- Sony SAL 1650 Инструкция по эксплуатации
- Icom IC-F410 Инструкция по эксплуатации
- Ardo TLE 66V4 EF Инструкция по эксплуатации
- Tokina AT-X 11-16 F/2.8 Инструкция по эксплуатации
- Icom IC-F420 Инструкция по эксплуатации
- Ardo C 6604 EB Инструкция по эксплуатации
- Tokina AT-X 16-28 F/2.8 ProFX Инструкция по эксплуатации
- Toshiba 22L1353 Инструкция по эксплуатации
- Ardo A 5604 EB Инструкция по эксплуатации
- Tokina AT-X M100 F/2.8 Macro Инструкция по эксплуатации