Nissan Note [2/28] Precautions

FAX-2

PRECAUTIONS

PFP:00001

Cautions

BDS0006R

Observe the following precautions when disassembling and servicing drive shaft.

● The joint of drive shaft cannot be disassembled. Do not attempt to disassemble it.

● Perform work in a location which is as dust-free and dirt-free as possible.

● Before disassembling and servicing, clean the outside of parts.

● The disassembly and service location must be clean. Care must be taken to prevent parts from becoming

dirty and to prevent the entry of foreign objects.

● Disassembled parts must be carefully reassembled in the correct order. If work is interrupted, a clean

cover must be placed over parts.

● Paper shop cloths must be used. Fabric shop cloths must not be used because of the danger of lint adher-

ing to parts.

● Disassembled parts (except for rubber parts) should be cleaned with kerosene which shall be removed by

blowing with air or wiping with paper shop cloths.

Precautions for Brake System

BDS0006S

● When installing rubber parts, final tightening must be carried out

under unladen condition* with tyres on ground.

*: Fuel, radiator coolant and engine oil full. Spare tyre, jack,

hand tools and mats in designated positions.

● Use flare nut wrench when removing or installing brake tubes.

● After installing removed suspension parts, check wheel align-

ment and adjust if necessary.

● Always tighten brake lines to the specified torque when install-

ing.

SBR820BA