Karcher IV 100/55 H B1 [19/282] Troubleshooting

Karcher IV 100/55 H B1 [19/282] Troubleshooting
– 7
Î Tilt the fastener for filter dedusting to-
wards the side.
Î Unscrew the handle for filter cleaning.
Î Remove the spring.
Î Unscrew the nut below the spring (you
will need a spanner with width 27 mm).
Î Open locks.
Î Remove the lid of the filter chamber.
1 Frame
2 H filter cartridge
3 M filter
Î Remove the H filter cartridge upward.
Î Immediately place the H filter cartridge
into the included bag and close it after
you remove it.
Î Dispose of the used H filter cartridge in
a dust-tight bag according to the statu-
tory provisions.
Î Open the knot of the tapes on the filter
and remove the frame.
Î Remove the M filter.
Î Immediately place the M filter into the
included bag and close it after you re-
move it.
Î Dispose off the used M filter in a dust-
tight bag according to the statutory pro-
visions.
Î Insert and secure the new filter in the re-
verse sequence of steps.
Note
In case of a failure (e.g. filter breakage) the
appliance must be turned off immediately.
The failure must be remedied before the
appliance is put into operation again.
Motor (suction turbine) does not start
No electrical voltage.
Î Check cables, plugs and socket.
Protective motor switch was triggered.
Î Reset switch.
Suction capacity decreases slowly
Filter, nozzle, suction hose or suction pipe
may be blocked.
Î Check, clean accessories. Clean filter.
Dust comes out during the vacuuming
Filter has not been fastened correctly or is
defective.
Î Check to see if filter is sitting properly;
replace if required.
Manometer shows a pressure level that
is not correct
Filter is blocked.
Î Switch off the appliance, clean the filter.
Warning
All checking and work on electrical parts
must be performed by an authorized elec-
trician. In the event of continuing faults,
contact Kärcher customer service.
Troubleshooting
19EN

Содержание

Скачать