Planta TM-M50 [29/31] Troubleshooting descriptions and troubleshooting

Attention! Do not use fuels or lubricants to lubricate the treadmill. To maintain this treadmill, use

only silicone oil sold in specialized stores.

Troubleshooting Descriptions and Troubleshooting:

There is a noise when exercising

1. Check if the walking belt has been partially tensioned on one side and loosened on the other.

To center it, follow the instructions described above in the Adjusting the Walking Belt section.

2. Check the presence and sufficiency of lubrication. If there is insufficient lubrication, follow the

instructions in the Lubrication of the Walking Belt section above.

The running belt has become worse (harder) to move or does not move under your feet

1. Check if the running belt is under tension on one side or the other. Adjust the tension with the

L-wrench if necessary.

2. Lift the edge of the treadmill and check if the treadmill is sufficiently well lubricated. If

lubrication is needed, follow the instructions in the Lubrication of the Belt and Treadmill Base

section.

Walking belt moves too fast (slips)

1. The walking belt is loose. Adjust the tension with the L-key.

The handrail does not lock at the desired level

Most likely, the adjusting bolts do not fall into the groove.

1. To eliminate this malfunction, repeat the steps described in paragraph 2 of the “Assembly of the

simulator” section: loosen the adjusting bolts and completely disconnect the handrail from the

running gear of the track.

2. Next, go directly to step 4: insert the base of the handrail into the undercarriage of the track

and fix the connection with the adjusting bolts at the required level.

Note: when following step 4, try to insert both sides of the base of the handrail simultaneously,

while keeping the adjusting bolts against the connecting holes. Once the handrail is at the

desired level, continue to slowly move the handrail until the hole in the base of the handrail

aligns with the hole in the base of the treadmill itself. Insert the adjusting bolts into the slots to

fix the handrail at the desired height.

LCD monitor does not display / does not display readings

1. correctly Check if the battery is installed correctly.

2. If the battery is installed correctly, it is probably out of charge. Replace the battery with a new

one. To replace the battery with a new one, follow the instructions described above in the

Installing and Replacing the Battery section.

3. Check if the monitor wires are connected according to steps 3 and 6 of the “Assembling the

Trainer” section.