Aten PE6108 [81/94] Rack mounting

Appendix

Rack Mounting

 Before working on the rack, make sure that the stabilizers are secured to

the rack, extended to the floor, and that the full weight of the rack rests on

the floor. Install front and side stabilizers on a single rack or front

stabilizers for joined multiple racks before working on the rack.

 Always load the rack from the bottom up, and load the heaviest item in the

rack first.

 Make sure that the rack is level and stable before extending a device from

the rack.

 Use caution when pressing the device rail release latches and sliding a

device into or out of a rack; the slide rails can pinch your fingers.

 After a device is inserted into the rack, carefully extend the rail into a

locking position, and then slide the device into the rack.

 Do not overload the AC supply branch circuit that provides power to the

rack. The total rack load should not exceed 80 percent of the branch circuit

rating.

 Make sure that all equipment used on the rack – including power strips and

other electrical connectors – is properly grounded.

 Ensure that proper airflow is provided to devices in the rack.

 Ensure that the operating ambient temperature of the rack environment

does not exceed the maximum ambient temperature specified for the

equipment by the manufacturer

 Do not step on or stand on any device when servicing other devices in a

rack.

The eco PDU’s Main Power Cord

Use the power cord supplied with this package. If it becomes necessary to

replace the cord supplied with this package, be sure to use a cord of at least the

same standard as the one provided.

Securing the Power Cables

To secure the cables in the eco PDU’s power outlets, use only the

ATEN Lok-U-Plug cable holders that have been specifically designed

to work with the eco PDU. Using any other kind of cable securing

device could be highly dangerous. Please contact your ATEN dealer

for information about ATEN Lok-U-Plugs.