SNR S2989G-48TX-DC — настройка функций безопасности и учета в сетевых устройствах [362/553]

S2989G-24TX Operation Manual

Chapter 6 Security Function Configuration

6-89

Switch (config-if-ethernet1/0/2)#portal enable configuration 1 vlan-pool 1

6.11.1.4 Captive Portal Authentication Troubleshooting

Encounter problems when using the redirection function, please check whether the

reasons are as follows:

 Whether launched the captive portal function and opened the portal configuration

switch. Both the captive portal and the portal configuration should be open; otherwise,

the captive portal function will not work, the client also cannot be redirect to the

specified page.

 The authentication server name of AAA module is same to the configured

authentication name of captive portal.

 Whether the port which connects the pc and switch is enabled portal authentication

function.

6.11.2

Accounting Function Configuration

6.11.2.1 Introduction to Accounting Function

The accounting function is used to monitoring and accounting users who using the

network resources. Client is unable to access the network resources before pass the

captive portal authentication, only through the portal authentication to access network

resources. Define user’s session duration to control the use of network resources time

and flow of information.

6.11.2.2 Accounting Function Configuration

Accounting function configuration task list is as below:

1. Configure RADIUS accounting server

1) Configure/delete accounting server address

2. Configure AAA accounting function

1) Enable/disable accounting service function

3. Configure captive portal accounting function

1) Block/unblock portal function

2) Configure/delete captive portal configuration name

3) Enable/disable captive portal accounting function

4) Configure/delete captive portal accounting server name

5) Configure/delete captive portal session time