SNR S2989G-48TX-DC — настройка MLD для IPv6: Руководство по конфигурации [536/553]

Превью страниц Страница 536 / 553

S2989G-24TX Operation Manual

Chapter 11 IPv6 Configuration

11-26

addresses of MLD use 130, 131 and 132 as data types denoting the three kinds of

messages mentioned above. Other logic is basically same as IGMPv2.

MLD protocol version2 use FF02::16 as destination address of membership report, and

143 as data type. The other logic of MLD Protocol version2 is similar to IGMP Protocol

version3.

11.5.1.2 MLD Configuration Task List

1、 Start MLD (Required)

2、 Configure MLD auxiliary parameters (Required)

（1） Configure MLD group parameters 1）

Configure MLD group filter conditions

（2） Configure MLD query parameters

1）Configure the interval of MLD sending query message

2）Configure the maximum response time of MLD query

3）Configure overtime of MLD query

3、 Shut down MLD Protocol

1. Start MLD Protocol

There is no special command for starting MLD Protocol on EDGECORE series layer

3 switches. MLD Protocol will automatically start up as long as any IPv6 multicast protocol

is started on corresponding interface.

Command

Explanation

Port Configuration Mode

ipv6 pim dense-mode | ipv6 pim

sparse-mode

Start MLD Protocol. The NO operation of

corresponding command shuts MLD Protocol.

(Required)

2. Configure MLD auxiliary parameters

（1） Configure MLD group parameters

1） Configure MLD group filter conditions

Command

Explanation

Global Mode

Ipv6 pim multicast-routing

To start Global IPv6 Multicast Protocol, the

precondition of starting MLD Protocol. The NO

operation of corresponding command shuts

ipv6 multicast protocol and MLD Protocol.

(Required)