APart MA200 [2/16] Safety first

WWW.APART-AUDIO.COM

Safety First!

• Read all documentation before operating your equipment.

• Retain all documentation for future reference.

• Save the carton and packing material even if the equipment has arrived in good condition.

Should you ever need to ship the unit, use only the original factory packing.

• Do not spill water or other liquids into or on the unit.

• Make sure power outlets conform to the power requirements listed on the back of the unit.

• Do not use the unit if the electrical power cord is frayed or broken.

• Always operate the unit with the AC ground wire connected to the electrical system ground.

• Have gain controls on ampliers turned down during power-up to prevent

speaker damage if there are high signal levels at the inputs.

• Do not connect the inputs / outputs of ampliers or consoles to any other voltage source, such

as a battery, mains source, or power supply, regardless of whether the amplier or console is

turned on or off.

• Power down & disconnect units from mains voltage before making connections.

• Do not use the unit near stoves, heat registers, radiators, or other heat producing devices.

• Do not block fan intake or exhaust ports. Do not operate equipment on a surface or in an

environment which may distort the normal ow of air around the unit. If the unit is used in an

Extremely dusty or smoky environment, the unit should be periodically “blown free” of dust.

• Do not remove the cover. Removing the cover will expose you to potentially dangerous volt-

ages.

• Do not drive the inputs with a signal level greater than that required to drive equipment to full

output.

• Do not run the output of any amplier back into another input.

• Do not ground the red output terminal, never connect a red output terminal to another red

output terminal.

• In case of mal-function this device should be serviced by qualied service personnel only.