Kurzweil PC3A6 [102/423] Impact

Program Mode

The Program FX (PROGFX) Page

6-47

Note: For each note triggered, you can only set the controller value that will scale the Depth parameter of

an envelope section before that section of the envelope is triggered. For controllers assigned for Attack, the

controller value used will be the last received before the note is triggered. For controllers assigned for

Decay,thecontrollervalueusedwillbethelastreceivedbeforethenalsectionoftheattackenvelope

reaches its maximum amplitude. For controllers assigned for Release, the controller value used will be the

last received before the note is released. To put it another way, for each envelope section, you cannot change

Press the PROGFX soft button to call up the Program FX (PROGFX) page. This is the page that

you will use to apply eects to a program, and to congure the routing of the various pre- and

post-FX audio signals. Eects chosen on this page aect every layer of the current program. The

section The Layer FX (LYR_FX) Page on page 6-49 contains information on using layer-specic

eects. The PROGFX page looks like this:

Parameter Range of Values Default

On the PC3A, a program can have up to 11 insert eects and 2 aux eects using up to 16 DSP

“units.” An insert is essentially just an eect that you apply to a program or layer, while aux

eects receive signal from all active programs’ aux sends. Note the 0/0 Units in the middle of the

top line of the page. This gure indicates how many of the total units are being used by the

highlighted insert; the left-hand number is the size of the insert, and the right-hand number is the

total number of units being used by the program.

If you exceed the maximum number of DSP units, the PC3A will notify you that you have done

so, and no eects will be applied to the program.