Home
Главная
Oursson
Мультиварки
MP5025PSD/BL
Руководство по эксплуатации Страница: 13

Oursson MP5025PSD/BL [13/32] Possible problems and solutions

Cleaning the device cover, Pic. E-3.

1. Open the cover of the multicooker by turning the

handle of the cover clockwise to the mark

, Pic.

D-1. Carefully remove the cover.

2. Detach the inner cover from the retaining clip, Pic.

E-3. Carefully remove the silicone O-ring from the

inner cover, Pic. E-3. Rinse the inner cover, silicone

ring in warm soapy water.

3. Dry and reinstall all parts.

Make sure that the inner cover and silicone O-

ring is installed correctly, otherwise steam may

escape unintended during operation.

Note:

The life of the O-ring is limited and depends on how of-

ten you cook and service the device.

DISPOSAL

To protect the environment, do not dispose of your device

in regular trash cans. Dispose of in accordance with cur-

rent regulations.

Cleaning the steam pressure reduction valve

Disconnect the steam vent valve carefully before clean-

ing. Disassemble the valve and wash in warm soapy

water. Rinse the valve and dry thoroughly. Reinstall the

valve.

To avoid damaging the device, do not use too

much physical force when removing and install-

ing the valve.

Note:

It is recommended to clean the steam valve and con-

densate container after each use of the device.

Cleaning the condensate container (moisture trap),

Pic. E-2.

• Carefully detach the condensate container and drain

the water. Wash, wipe it dry and put it back in place.

Possible Problem Possible Cause Solutions

Device doesn’t turn on

1. The power cable is not

connected to the mains.

2. There is no voltage in the

power supply.

1. Make sure the power cable is plugged in.

2. Disconnect the device from the power supply and

wait until the voltage returns to normal.

The cover does not close

properly

Food stuck on the O-ring may be

preventing the lid from closing

properly.

Check the device for foreign objects and dirt.

The cover of the multi-

cooker does not open

• There may be overpressure

inside the device.

• Steam pressure relief

mechanism is not working

properly.

• Let the appliance cool down a bit, turn the steam

release valve to position

• Gently push the ball of the steam pressure

control mechanism down. If the problem persists,

call for service.

Liquid ows out from

under the cover of the

multicooker

The steam release mechanism

may be dirty.

Check the steam pressure release mechanism for

foreign debris.

The dish is not completely

cooked

1. Incorrect proportions of ingre-

dients and water.

2. Too many ingredients have

been loaded.

1. Follow the proportions of the ingredients

according to the recipes. Check the quality of

the ingredients. Extend the cooking time.

2. Do not ll the bowl above the MAX mark.

Steam or liquid comes out

between the cover and

the multicooker

1. The O-ring may be installed

incorrectly.

2. Too many ingredients/water

have been loaded in the bowl.

3. The cover is not closed

properly.

1. Unplug the multicooker immediately. Make sure the

O-ring on the cover is seated correctly, not dam-

aged, blocked by foreign objects or food debris.

If necessary, contact a service center to check or

replace the O-ring.

2. Do not ll the bowl above the MAX mark.

3. Close the cover as described above.

POSSIBLE PROBLEMS AND SOLUTIONS

Oursson MP5025PSD/BL [13/32] Possible problems and solutions

Содержание

Похожие устройства