Tc Electronic G-MAJOR [14/52] The display
![Tc Electronic G-MAJOR [14/52] The display](/views2/1011810/page14/bge.png)
12
THE DISPLAY
Input Meter
Overload
LEDs
Input Type
Indicator
Matrix - indication of
currently used Routing
Block Levels -
In/Out and Mix
Damp
Compression/
Noise Gate
Preset
Number
Indicators of:
Received
MIDI
Factory/User
preset bank
Edit
indication
TunerDetected Input Pitch
Input Meters
Peak meter showing Input level.
The Meter range is: 0, -3, -6, -12, -18, -24, -40dB.
To set correct Input level:
Select the “loudest” sounds containing the most
dynamic content on the equipment you are
feeding the G•Major with, e.g. your preamp.
This will probably be a clean sound. Adjust the
Input level at the G•Major so the -3dB LED
flashes frequently and the -0dB LED flashes
only at absolutely highest levels.
Input Overload LEDs
The Overload LEDs indicates one of two
situations:
The Input level is too hot and therefore
overloading or there is an internal DSP
overflow. The Overload LED is lit when 1
sample is @ 0dBFS.
Reduce either the Output of the device feeding
the G•Major or Input gain on the G•Major using
the Input level knob.
Input Type and Clock
Input selection is done in the Utility section
accessed by pressing the I/O key.
Analog/Digit
al: Indicates selected Input mode.
Lock: Indicates that digital lock is achieved with
a device connected to the Digital Input.
44.1/48kHz:
Indicates the current Clock Rate.
DI LED: Indicates that external digital Clock
Input is selected.
If a digital device is connected to the digital
Input on the G•Major but no lock is achieved,
the Lock indication will blink. Check cables and
Clock Rate on the connected device and try
again.
Tuner
The G•Major holds a Tuner, which is always
active. The two arrows will both be lit when the
instrument is in tune.
If a TC Electronic G•Minor MIDI pedal (optional)
is used you can also have the Tuner displayed
in the Pedal.
The Matrix
The G•Major holds 3 different effect block
routing options.
This matrix indicates which of the three that is
used.
Levels Section
These parameters refer only to the block being
edited.
PPM - Peak Program Meter:
Indicates the level of the block currently being
edited.
IN Meter:
Indicates the present Input Level in the block
currently being edited.
OUT Meter:
Indicates the parameter position of the Output
Level in the block currently being edited.
Содержание
- Important safety instructions 3
- Important safety instructions 4
- Table of contents 5
- Introduction 6
- Introduction 7
- Front panel overview 8
- Front panel overview 9
- Rear panel 10
- Signal flow 11
- Basic setups 12
- Connecting and setting up the g major 12
- Basic setups 13
- Combined setup with regular effect pedals a g major and a midi pedal 13
- Connecting and setting up the g major 13
- The display 14
- Preset types 15
- Recall 15
- The display preset handling 15
- I o setup 16
- Preset handling i o setup 16
- I o setup midi util 17
- Midi util 18
- Midi util 19
- The tuner 19
- Midi mapping 20
- Midi util 20
- Channel switching of ext preamp using relay 1 2 21
- Levels all relay 1 2 21
- Channel switching tap tempo 22
- Tap menu 22
- Y splitter cable stereo to stereo jack cable 22
- Routing menu 23
- Routings 23
- Controlling the g major 24
- Introduction 24
- The mod menu 24
- Assigning modifiers 25
- Controlling the g major 25
- Controlling the g major 26
- How to 27
- How to 28
- Effect blocks noise gate 29
- Introduction 29
- Noise gate eq 30
- Compressor 31
- Chorus 32
- Classic chorus 32
- Advanced chorus 33
- Chorus 33
- Advanced flanger 34
- Classic flanger 34
- Flanger 34
- Flanger vibrato 35
- Vibrato 35
- Auto resonance filter 36
- Resonance filter 36
- Phaser 37
- Vintage phaser smooth phaser 37
- Panner 38
- Tremolo 38
- Tremolo panner 38
- Introduction 39
- Ping pong 39
- Dual delay 40
- Dynamic delay 40
- Detune 42
- Whammy 42
- Pitch shifter 43
- Reverb 44
- Spring 44
- Reverb 45
- Reverb 46
- Reverb 47
- Appendix 48
- Midi implementation chart 48
- Appendix 49
- Due continuous development these specifications are subject to change without notice 49
- Technical specifications 49
- Preset list 50
- Frequently asked questions 51
- Frequently asked questions 52
Похожие устройства
- Casio EX-ZS5 Black Инструкция по эксплуатации
- Mega 4120 XAS Инструкция по эксплуатации
- Maxwell MW-1012 Инструкция по эксплуатации
- Toshiba SD-57HTKR Инструкция по эксплуатации
- Hertz HP 1 KD Инструкция по эксплуатации
- Tc Electronic G-SHARP Инструкция по эксплуатации
- Casio EX-ZS10 Pink Инструкция по эксплуатации
- Champion 3053-C2 Инструкция по эксплуатации
- Toshiba SD-47HKSR Инструкция по эксплуатации
- Pandora программирование брелков Инструкция по эксплуатации
- Tc Electronic G-SYSTEM Инструкция по эксплуатации
- Hertz Hertz HE 2 Инструкция по эксплуатации
- Casio EX-ZS10 Silver Инструкция по эксплуатации
- Stiga Collector 46 B 299174621/S11 Инструкция по эксплуатации
- Bosch TWK 8611 Инструкция по эксплуатации
- Toshiba SD-44HKSE Инструкция по эксплуатации
- Pandora RX-100 (2004 г) Инструкция по эксплуатации
- Casio EX-ZS10 Blue Инструкция по эксплуатации
- Tc Electronic SCF Инструкция по эксплуатации
- Hertz HE 4 Инструкция по эксплуатации