![Tc Electronic G-MAJOR [51/52] Frequently asked questions](/img/pdf.png)
Tc Electronic G-MAJOR [51/52] Frequently asked questions
![Tc Electronic G-MAJOR [51/52] Frequently asked questions](/views2/1011810/page51/bg33.png)
49
FREQUENTLY ASKED QUESTIONS
This section give answers to some of the
most frequently asked questions regarding
the G•Major. More information can be found
via TC Support Interactive, which can be
accessed via www.tcelectronic.com
Which MIDI foot controller is the most
suitable for the G•Major?
There are many foot-controllers that works fine
with the G•Major. However, to fully utilize the
facilities in the G•Major you should look for a
controller capable of sending
MIDI Control
Changes alternating values between 0 and 127
and MIDI Program changes.
Control Changes are used for bypassing
effects, tapping tempo etc. Program changes
are used for recalling/loading presets.
What is the proper way to adjust the Input
level on the G•Major?
Play with a high level clean sound. Though the
distorted sounds may seam louder than clean
sounds in general, the highest dynamic range
is typically found in clean sounds. The Input
meter should show -3dB at peaks and -12dB to
-6dB in average.
If adjusting the Output level of your preamp (or
other device placed just before the G•Major in
the signal path) and adjusting the Input level on
the front panel of the G•Major, does not give
you the desired Input level range, you should
change the Input Range parameter found in the
G•Major I/O menu.
How to setup a G•Major with a MIDI
controllable preamp
The G•Major is easily setup with a MIDI
preamp.
• Connect MIDI Out from your MIDI board to
MIDI In on your preamp.
• Connect MIDI Thru/Out from the preamp to
MIDI In on the G•Major.
The G•Major has a MIDI mapping function that
allows incoming program changes to recall any
preset. See page 18 for more information.
How to reset the G•Major?
• Power off the G•Major on the front panel.
• Press and hold the TAP key and power on
again.
• Select either “Reset Sys Param” to reset all
system parameters while keeping your
programmed user presets or “Clear all
Presets” to clear the User bank only.
Amp switching of specific analog preamps
Contact the amp manufacturer to get
schematics on your specific preamp. Page 19
of this manual explains how the relays of the
G•Major operate.
Lost preset at power off
If you power off using the rear panel mains
switch while a preset is being edited your
changes to that specific preset will be lost. You
will not loose your settings if you use the front
panel POWER key while keeping mains power
connected on the rear panel.
However, a good rule of thumb: Save settings
before powering off the G•Major.
Uploading software to the G•Major
From time to time new software will be
available for the G•Major. To upload this
software to the G•Major you will need a PC
computer with a standard MIDI interface
installed. The software can be downloaded from
www.tcelectronic.com. Follow the instructions
given in the upload application.
G•Major hangs during software update
procedure.
Depending on the MIDI interface used you may
encounter a “download error”. Retry once or
twice and the software should update correctly.
Using the G•Major in a combo amplifier
effect-loop
Many combo amplifiers have an effect loop.
However, there are no standards for these
loops. At times it can be hard to even see
whether we are talking about a serial or parallel
loop.
A
serial loop interrupts the signal path between
the preamp and the power amp - just as if they
were two separate units. This means the entire
signal from the preamp travels through the
processor and re-enters the power stage. It is
basically a one-lane road going from one place
to another.
Parallel loop
s offer two paths from the preamp
to the power amp. One path is a direct
connection from the preamp to the power amp
as if the amp had no loop at all. The other path
sends the preamp signal to the effect processor
(via the loop) and then routes it back to the
power amp, mixing it with the direct (dry) signal.
Most amps that offer a parallel effects loop
Содержание
- Important safety instructions 3
- Important safety instructions 4
- Table of contents 5
- Introduction 6
- Introduction 7
- Front panel overview 8
- Front panel overview 9
- Rear panel 10
- Signal flow 11
- Basic setups 12
- Connecting and setting up the g major 12
- Basic setups 13
- Combined setup with regular effect pedals a g major and a midi pedal 13
- Connecting and setting up the g major 13
- The display 14
- Preset types 15
- Recall 15
- The display preset handling 15
- I o setup 16
- Preset handling i o setup 16
- I o setup midi util 17
- Midi util 18
- Midi util 19
- The tuner 19
- Midi mapping 20
- Midi util 20
- Channel switching of ext preamp using relay 1 2 21
- Levels all relay 1 2 21
- Channel switching tap tempo 22
- Tap menu 22
- Y splitter cable stereo to stereo jack cable 22
- Routing menu 23
- Routings 23
- Controlling the g major 24
- Introduction 24
- The mod menu 24
- Assigning modifiers 25
- Controlling the g major 25
- Controlling the g major 26
- How to 27
- How to 28
- Effect blocks noise gate 29
- Introduction 29
- Noise gate eq 30
- Compressor 31
- Chorus 32
- Classic chorus 32
- Advanced chorus 33
- Chorus 33
- Advanced flanger 34
- Classic flanger 34
- Flanger 34
- Flanger vibrato 35
- Vibrato 35
- Auto resonance filter 36
- Resonance filter 36
- Phaser 37
- Vintage phaser smooth phaser 37
- Panner 38
- Tremolo 38
- Tremolo panner 38
- Introduction 39
- Ping pong 39
- Dual delay 40
- Dynamic delay 40
- Detune 42
- Whammy 42
- Pitch shifter 43
- Reverb 44
- Spring 44
- Reverb 45
- Reverb 46
- Reverb 47
- Appendix 48
- Midi implementation chart 48
- Appendix 49
- Due continuous development these specifications are subject to change without notice 49
- Technical specifications 49
- Preset list 50
- Frequently asked questions 51
- Frequently asked questions 52
Похожие устройства
- Casio EX-ZS5 Black Инструкция по эксплуатации
- Mega 4120 XAS Инструкция по эксплуатации
- Maxwell MW-1012 Инструкция по эксплуатации
- Toshiba SD-57HTKR Инструкция по эксплуатации
- Hertz HP 1 KD Инструкция по эксплуатации
- Tc Electronic G-SHARP Инструкция по эксплуатации
- Casio EX-ZS10 Pink Инструкция по эксплуатации
- Champion 3053-C2 Инструкция по эксплуатации
- Toshiba SD-47HKSR Инструкция по эксплуатации
- Pandora программирование брелков Инструкция по эксплуатации
- Tc Electronic G-SYSTEM Инструкция по эксплуатации
- Hertz Hertz HE 2 Инструкция по эксплуатации
- Casio EX-ZS10 Silver Инструкция по эксплуатации
- Stiga Collector 46 B 299174621/S11 Инструкция по эксплуатации
- Bosch TWK 8611 Инструкция по эксплуатации
- Toshiba SD-44HKSE Инструкция по эксплуатации
- Pandora RX-100 (2004 г) Инструкция по эксплуатации
- Casio EX-ZS10 Blue Инструкция по эксплуатации
- Tc Electronic SCF Инструкция по эксплуатации
- Hertz HE 4 Инструкция по эксплуатации