![Tc Electronic G-MAJOR [18/52] Midi util](/img/pdf.png)
Tc Electronic G-MAJOR [18/52] Midi util
![Tc Electronic G-MAJOR [18/52] Midi util](/views2/1011810/page18/bg12.png)
16
MIDI/UTIL
the pedal is pressed. Alternating pedal types
“stays connected” when pressed, and must be
pressed again to be deactivated. Default setting
is Expression.
Pedal Calibrate
For the G•Major to respond correctly to the
actions performed by a connected Expression
pedal, the G•Major must be calibrated to the
specific pedal.
• Connect your pedal and select appropriate
pedal type.
• Select Pedal calibrate and press ENTER.
• Move pedal to Max position (heel up) and
press ENTER.
• Move pedal to Min position (heel down) and
press ENTER.
• Your pedal has been calibrated.
Depending on the pedal type you are
using you can be asked to repeat steps
3 and 4.
Tuner Ref.
Range: 420 to 460Hz
Sets the master Tune frequency of the built in
Tuner. 440Hz is the standard setting.
Tuner Mode
The Tuner can operate with two different
accuracies.
Fine
T
une
Maximum accuracy. Use this mode when fine-
tuning your guitar.
Coarse
Slightly less accurate mode, allowing for fast
results in a live situation.
Tuner Range
Sets the range of the Tuner. Select between
Bass, 7-string Guitar and Guitar. The accuracy
of the Tuner is dependent on this tuner range,
and it is therefore important to set this
parameter according to the instrument you
desire to tune.
Send Tuner
Set this parameter to “On” to feed a connected
G•Minor with Tuner information.
MOD Master
Range: Read/Ignore
If you are not acquainted with Modifiers you
can read about them in the Modifier Section of
this manual. In short - parameter values can be
controlled via an external controller such as
e.g. a MIDI Expression pedal. If setup to control
e.g. the Preset Out Level you must decide via
this MOD Master parameter how you would like
the G•Major to respond to the position of the
Expression pedal at preset changes. Choosing
between the following options depends very
much on what your Modifier is set up to
do/control.
Mod
If set to “Mod” the G•Major will at any preset
change check the position of the connected
external Controller and respond to this position
thereby ignoring the Modifier value for the
relevant parameter.
Preset
If set to “Preset” the G•Major will ignore the
position of the connected External controller
and load the Modifier value stored with the
preset.
If using Ignore function with an
Expression Pedal that is controlling a
level parameter, you should be aware
that next time you move the pedal the
parameter will jump to the value
equivalent to the pedal position. This
could in some cases mean a
considerable jump in level.
Tap Master
Preset : Tempo will follow presets.
Tap : Tempo will follow the Global tapped
tempo.
Tap Unit
Selects whether the tapped tempo in the Tap
Menu should be displayed in milliseconds (ms)
or in Beats Pr Minute (BPM).
MIDI Clock
Range: On/Off
The Global Tap Tempo can be synchronized to
an Incoming MIDI clock from e.g. a MIDI
sequencer.
Thereby you can e.g. keep a Delay Time in
sync with the Tempo of the song.
Содержание
- Important safety instructions 3
- Important safety instructions 4
- Table of contents 5
- Introduction 6
- Introduction 7
- Front panel overview 8
- Front panel overview 9
- Rear panel 10
- Signal flow 11
- Basic setups 12
- Connecting and setting up the g major 12
- Basic setups 13
- Combined setup with regular effect pedals a g major and a midi pedal 13
- Connecting and setting up the g major 13
- The display 14
- Preset types 15
- Recall 15
- The display preset handling 15
- I o setup 16
- Preset handling i o setup 16
- I o setup midi util 17
- Midi util 18
- Midi util 19
- The tuner 19
- Midi mapping 20
- Midi util 20
- Channel switching of ext preamp using relay 1 2 21
- Levels all relay 1 2 21
- Channel switching tap tempo 22
- Tap menu 22
- Y splitter cable stereo to stereo jack cable 22
- Routing menu 23
- Routings 23
- Controlling the g major 24
- Introduction 24
- The mod menu 24
- Assigning modifiers 25
- Controlling the g major 25
- Controlling the g major 26
- How to 27
- How to 28
- Effect blocks noise gate 29
- Introduction 29
- Noise gate eq 30
- Compressor 31
- Chorus 32
- Classic chorus 32
- Advanced chorus 33
- Chorus 33
- Advanced flanger 34
- Classic flanger 34
- Flanger 34
- Flanger vibrato 35
- Vibrato 35
- Auto resonance filter 36
- Resonance filter 36
- Phaser 37
- Vintage phaser smooth phaser 37
- Panner 38
- Tremolo 38
- Tremolo panner 38
- Introduction 39
- Ping pong 39
- Dual delay 40
- Dynamic delay 40
- Detune 42
- Whammy 42
- Pitch shifter 43
- Reverb 44
- Spring 44
- Reverb 45
- Reverb 46
- Reverb 47
- Appendix 48
- Midi implementation chart 48
- Appendix 49
- Due continuous development these specifications are subject to change without notice 49
- Technical specifications 49
- Preset list 50
- Frequently asked questions 51
- Frequently asked questions 52
Похожие устройства
- Casio EX-ZS5 Black Инструкция по эксплуатации
- Mega 4120 XAS Инструкция по эксплуатации
- Maxwell MW-1012 Инструкция по эксплуатации
- Toshiba SD-57HTKR Инструкция по эксплуатации
- Hertz HP 1 KD Инструкция по эксплуатации
- Tc Electronic G-SHARP Инструкция по эксплуатации
- Casio EX-ZS10 Pink Инструкция по эксплуатации
- Champion 3053-C2 Инструкция по эксплуатации
- Toshiba SD-47HKSR Инструкция по эксплуатации
- Pandora программирование брелков Инструкция по эксплуатации
- Tc Electronic G-SYSTEM Инструкция по эксплуатации
- Hertz Hertz HE 2 Инструкция по эксплуатации
- Casio EX-ZS10 Silver Инструкция по эксплуатации
- Stiga Collector 46 B 299174621/S11 Инструкция по эксплуатации
- Bosch TWK 8611 Инструкция по эксплуатации
- Toshiba SD-44HKSE Инструкция по эксплуатации
- Pandora RX-100 (2004 г) Инструкция по эксплуатации
- Casio EX-ZS10 Blue Инструкция по эксплуатации
- Tc Electronic SCF Инструкция по эксплуатации
- Hertz HE 4 Инструкция по эксплуатации