Thomas TWIN T2 PARQUET [19/83] Wash cleaning
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Thomas TWIN T2 PARQUET [19/83] Wash cleaning

Thomas TWIN T2 PARQUET [19/83] Wash cleaning
19
Fill up with cleaning concentrate and water through the grip
lug (max. 2.4 litres).
We recommend THOMAS ProTex original concentrated
cleaning agent for cleaning carpets.
See label on the cleaning concentrate bottle for application
and dosage.
Use hand warm water (max. 30°C).
Connect up suction hose and fit telescopic suction tube.
Fit carpet spray nozzle, spraying hose to the suction tube with
fast coupling and move upwards and place on the shut-out
valve and lock by turning. Afterwards fasten the spray hose
by means of the two tube clips on the suction tube.
Pull out the mains power supply plug and cable from the
appliance and connect up.
Switch on the appliance and set for maximum suction power. Switch
on pump. Control lamp comes on.
Press the lever on the shut-off valve (24) until clean fluid
escapes. Draw the nozzle straight over the carpet and press
it down at the same time. The spraying volume can be set as
required by means of the setting wheel on the handle. Release
the valve lever to stop spraying at the end of one run or when
stopping work. When the sprayed liquid has been sucked up,
lift the nozzle and begin a new run but overlap slightly. In this
way you can clean the entire area section by section.
Should there still be traces of liquid remaining on the cleaned
areas this liquid can be sucked up without having to spray
again.
Make sure that the mechanical suction controller (25) is
completely closed.
In the case of very stubborn dirt you can apply cleaning fluid
while moving the carpet spraying nozzle forwards. The same
treatment can also be applied by just putting the pump into
operation.
Ensure that you do not spread too much liquid over the carpeting
since this may cause waves or bumps in the carpet. However, these
will disappear again after being allowed to dry for a longer period
of time.
Absaugen und
Aufrichten
Arbeitsrichtung
Einsprühen
Saugrohr
Druckleitung
Lösen und Auswaschen
Suction tube
Releasing and washing out
Spraying
Sucking up and
straightening
Pressure line
Working direction
Wash cleaning
Information for use
• Caution! Petrol, thinners, heating oil, etc., can develop explosive
vapours and mixtures when mixed with the intake air.
• Acetone, acids and solvents can attack the materials used in the
production of the appliance. Both clean and dirty water can be
sucked up without any hesitation.
• After sucking up liquids always clean and dry the dirty water tank
and all the parts used.
• Never suck up liquids without the dirty water tank.
• Your THOMAS TWIN T2 PARQUET is not suitable for sucking up
larger quantities of liquid from containers or basins.
• Caution! Never operate the pump without liquid.
• Always empty and clean the appliance every time it is used for
wet cleaning. Dirty water and moist parts propagate the growth
of bacteria and fungi (see cleaning and maintenance instructions).
Only use THOMAS original products and parts to ensure
perfect cleaning results.
You can get further supplies of the concentrated cleaning
agent from your specialist dealer or the THOMAS Works Customer
Service Department.
Before cleaning carpets
• Make sure that everything you want to wet clean is also suitable
for wet cleaning. Do not wet clean your sensitive, hand-woven or
non-fast dyed carpets, for example.
To check this put a little cleaning agent solution on a white cloth and
rub on the carpet at a not too obvious spot. It can be assumed that
the dye is colourfast should no traces of dye appear on the cloth.
Should this not be the case do not wet clean the carpet.
Please consult your specialist carpet dealer should you have any
doubts.
Should the carpet have been shampooed earlier on it may well
be that increased foaming will occur in the dirty water tank when
using the THOMAS TWIN T2 PARQUET for the first time. Add half
a cup of vinegar to the dirty water tank to prevent any further
foaming.
Immediately switch off the appliance and empty the dirty water
tank should foam escape from the air outlet.
When using the THOMAS cleaning concentrate for thorough
cleaning there will be no increased foaming because this concen-
trated cleaning agent contains a special anti-foaming agent.
You should not walk over your cleaned carpet as long as it is wet.
The room should be well ventilated both while cleaning and after-
wards to ensure quick drying.
Carpet cleaning
Put the 2-piece anti-swash insert together.
Draw out the AQUA filter from the dirty water tank by the grip
and fit the anti-swash insert.
Remove HEPA filter from the appliance.
Fit the anti-swash insert and dirty water tank on the appliance.
Make sure that both the wet filter (13a) and the motor protection
filter (15) are fitted.
Remove the fresh water tank for filling (draw tank straight
upwards and out of the cleaner) or fill up directly in the appliance.
In this case you have to lift up fresh water tank cover.
When filling make sure that no impurities get
into the fresh water tank which will prevent the
closing valve from not functioning properly.
Spray extraction system
• Spray the cleaning solvent deep into the carpet under pressure
• This releases the dirt and washes out deep down into the fibres
• Suck up the dirty water at full power and straighten up the
carpet pile again.
This should be always carried out in a single operation.

Содержание

Похожие устройства

Скачать