Thomas TWIN T2 PARQUET [20/83] L 250 ml min

Thomas TWIN T2 PARQUET [20/83] L 250 ml min
20
Empty the dirty water tank after you have used up all the
water and completely fill the cleansing agent tank from the
fresh water tank to prevent the appliance being switched off
automatically.
Should you not observe the above-mentioned instructions the
float will automatically switch off the appliance as soon as
the dirty water tank is full. (You will clearly hear the motor be
running at a higher speed.)
Switch off appliance, disconnect the mains plug and empty the
dirty water tank.
Hard floor cleaning
Drop the hard floor adapter over
the carpet spraying nozzle and
lock by means of the slide.
By using this system you can clean
and dry your hard floor coverings
such as tiles, stone floors and PVC
at one and the same time.
See carpet cleaning for procedure.
We recommend THOMAS ProFloor concentrated cleaning
agent for hard floor cleaning.
Maintenance cleaning of smooth floor coverings such
as linoleum, PVC, tiles, polished stone floors and lami-
nate floors with the microfibre pad
– General instructions:
Proper care of floors is an essential component
under our terms of guarantee!
To be observed without fail are the special care
instructions of the manufacturer of the floor
coverings.
The surface protection finish can be damaged or destroyed when
cleaning and using aggressive universal cleaners.
Maintenance cleaning is to be carried out by dust suction or by wiping
over with moist cloth.
Atomised moisturisation means: The floor must be completely dry
after 3-5 minutes. This method is only to be used on laminate floors
when recommended by manufacturer.
Wash the microfibre pad before using it for the first time to remove
any possible residue given as a result of the production process.
We recommend THOMAS ProFloor cleaning concentrate for
maintenance cleaning of smooth floor coverings such as linoleum,
PVC, tiles, polished stone floors and laminate floors.
Dismantling/assembling:
To remove the fold back hard floor adapter from the carpet spraying
nozzle, push the slide upwards and then press the red nozzle lock
towards the inside. Release the hard floor adapter from its hinge and
remove.
Proceed in the reverse order to fit the wipe adapter.
The microfibre pad is to be run over the strip so that the nozzle suction
channel is open or remains open.
Set the water volume control-
ler (25) to “min”. Start spraying
operation for 2–3 seconds and
moisturise microfibre pad (white).
Wetting the surface has to be
avoided because under these cir-
cumstances wetting of edge area
of parquet or floor elements is
not adequately protected against
moisture.
Window cleaning
Fit the wipe adapter to the carpet spray nozzle. To assemble see
maintenance cleaning instructions for smooth floors.
The microfibre pad for window cleaning (grey) is to be connected to
the wiper.
You can clean and dry your windows and glass surfaces at the same
time by this method.
Procedure see carpet cleaning
Upholstery cleaning
Use the upholstery spraying nozzle to clean upholstered furniture, car
seats, etc. Push this nozzle on the grip. Connect the spraying hose to
the shut-off valve.
When cleaning upholstery make sure that not too much liquid is
applied because you will have to take a longer drying time into
account depending on the floor underneath.
Flow rate control on the hand grip.
See carpet cleaning for procedure.
We recommend THOMAS ProTex concentrated cleaning
agent for upholstery cleaning.
2.
1.
l
250 ml
min.
1.
2.
3.
5.
4.
6.

Содержание