Thomas TWIN T2 PARQUET [23/83] What to do when

23

Should your THOMAS TWIN T2 PARQUET not function to your satisfaction first use the check list given below whether the cause of the irregularity

is just a small matter before you contact the Customer Service Department.

Occurring irregularities,

faulty functions - Reasons, elimination

General (all functions)

 The appliance cannot be started up

Are the mains connection cable, plug and plugbox in order? → Before checking disconnect the

main power supply plug and only have any necessary repairs are only to be carried out by

bath? → Check

Is the intake filter blocked directly by dirt or are the nozzles blocked in the intake connector?

→ Dismantle and clean or rinse out with water.

 Suction power slowly decreases

Is the HEPA filter blocked? → Clean the HEPA filter.

Are nozzles, suction tube or suction hose blocked by coarse dirt? → Flexing the tube during

operation will release any dust and dirt blocking the tube and clear the stoppage.

 Inadequate suction power

Is the Aqua injection nozzle blocked in the intake connector? → Dismantle and clean or rinse

out with water.

Is the mechanical suction power controller on the hand grip open? → Close the slider on the

hand grip.

 A large number of drops of water have

collected on the inside of the housing

cover

In all probability there is too much dust in the AQUAFILTER system

→ Clean the AQUAFILTER system, renew the water

Washing cleaning

 The suction power decreases suddenly

Is the dirty water tank full (float has responded)? → Empty the tank.

Has the dirty water tank been fitted together with the anti-swash insert, wet filter and motor

protection filter? → Switch off the appliance immediately, dry the appliance and fit missing

parts.

 An unusually large pool of water has

collected in the suction chamber (a few

drops are absolutely normal)

Are seals and sealing surfaces extremely dirty? → Clean.

Have you forgotten to fit the wet filter for the anti-swash insert.

 Unusual heavy development of foam in

the dirty water tank

strongly.

Is the tank connection opening blocked? → Remove fresh water tank and thoroughly suck out

the tank connection opening (connection point between fresh water tank and housing) with

the crevice nozzle to remove any possible contamination and dirt.

 Is there too much residual moisture in the

system and liquid is no longer sucked up

properly

Is the electronic suction power controller set to MIN? → Set suction power to MAX (orange

lamp lights up).

Is the mechanical suction power controller on the hand grip open? → Close the slider on the