Adaptec asr-5405 kit [97/116] Running the afu from the command line
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Adaptec asr-5405 kit [97/116] Running the afu from the command line

Adaptec asr-5405 kit [97/116] Running the afu from the command line
Running the Menu-based AFU
To run the menu-based AFU:
1. Shut down your operating system and reboot to DOS from a bootable DOS oppy disk or from a DOS
partition on a bootable drive. (You can use a disk drive connected to the controller you are updating.)
If your computer isn’t set up to boot from the bootable oppy disk, enter the system setup utility
and change the setting.
2. Insert the rmware update disk (created using the steps above) containing AFU.exe
3. At the DOS command prompt, type AFU with no arguments.
The AFU's main menu is displayed.
4. Select Select Controllers, then select the Adaptec RAID controller(s) to be ashed.
To update multiple RAID controllers in the same system, update the boot controller's ash rst,
restart the computer, then update the ash for the remaining controllers.
5. Select Select an Operation.
6. Choose the operation you want, then follow the on-screen instructions to complete the task:
• Update ash image—Updates all the ash components on a RAID controller with the ash image
data from the UFI le.
• Save ash image—Reads the contents of a RAID controller's ash components and saves the
data to a UFI le, which you can use to restore a RAID controller's ash if required.
• Verify ash image—Reads the contents of a RAID controller's ash components and compares
it to the contents of the specied UFI le.
• Display ash information—Displays version information about a RAID controller's ash
components.
7. Complete the ash operation and restart your computer before trying to use the RAID controller
again. (You can not use your RAID controller while you are updating its ash.)
The AFU processes the selected command and reports either success or an error message code.
Running the AFU from the Command Line
Note: You can also run a menu-based AFU (see Running the Menu-based AFU on page
97).
To run the AFU from the command line:
1. Shut down your operating system and reboot to DOS from a bootable DOS oppy disk or from a DOS
partition on a bootable drive. (You can use a disk connected to the controller you're updating.) If
your computer isn't set up to boot from the bootable oppy disk, enter the system setup utility to
change the setting.
2. Insert the rmware update disk containing AFU.exe.
3. At the DOS command, type AFU followed by a command (see AFU Commands on page 97) and any
switches you want.
Note: To nd a controller number, type AFU LIST, then press Enter.
The AFU processes the command and reports either success or an error message code.
To update a RAID controller's ash using the command line utility ARCCONF, see Updating the Flash
Using the AFU Command Line on page 100.
AFU Commands
This section lists the available AFU commands.
97Proprietary and Condential to PMC-Sierra, Inc., and for its customers.
Document No.: CDP-00310-01-A Rev. A, Issue
Serial Attached SCSI RAID Controllers Installation and User's Guide

Содержание

Похожие устройства

Скачать