Bestway 57212 [4/24] S s 001477 21x28 cm 梯形水池b版 js yf 2012 b 01907 英

4

3. From outside of the pool, tighten the Connector Nut onto the assembled Unit.(See Fig. 4)

4. Hand-tighten the Control Valve to the assembled Unit. (See Fig. 5)

NOTE: Check that both the Control Valve Gasket and O-ring are correctly positioned on the

Control Valve.

5. Refer to the pool manual for the rest of the pool installation.

OPERATION NOTE: Use the control screw on top of the Control Valve to open and close the

Valve. (See Fig. 6)

6. Make sure the valve is closed.

2. Turn water off. Check that the water is not collecting on any side to ensure the pool is level. If pool is not level, drain

water and re-level ground by digging out. Never attempt to move the pool with water in it, serious personal injury or

damage to the pool may result.(See Fig. 9)

NOTE: Your pool may contain up to xxxxx liters / xxxx gallons which equals xxxxx pounds of pressure. If your pool

has any bulge or uneven side then the pool is not level, the sides may burst and the water may discharge suddenly

causing serious personal injury and/or damage to property.

3. Fill pool to lowest pump valve.

STOP

4. Turn water off. Check valves for secure fit.

5. Fill pool until water capacity is 80%, up to the bottom of the inflated ring of the pool so that the sides are smooth and

Fig. 8

Proper Water Level

Fig. 9

Flat, Level Ground - CORRECT

Bumpy, Sloping Ground - INCORRECT

Fig. 7

Pool Outside

NOTE: The filter pump is used to circulate the water and to filter small particles to keep your water free of suspended

dirt particles. In order to keep your pool water clean and hygienic you must add chemicals.

To keep your pool clean:

1. Contact your local pool supply shop for advice and purchase of chemicals and PH kits.One of the most important

factors to increase the life of the liner is to keep continuosly clean and healty water. Please follow strictly the

instructions from professional technicians for the water treatment through the use of chemicals.

2. Locate a bucket of water next to pool to clean users’ feet before entering pool.

3. Cover the pool when not in use.

4. Skim pool regularly to avoid settled dirt.

5. Check the filter cartridge regularly, change filter cartridge if filter cartridge remains soiled or discolored. Suggest

ATTENTION: Do not use pump when pool is in use.

During the season of use of the swimming pool, the filtration system must be necessarily put into service every day,

enough for a long time to assure at least a complete renewal of the volume of water.

Repair

If your pool is damaged, use the repair patch. -see FAQ’s for instructions.

Dismantling

1. Unscrew the drain valve cap on the outside of the pool counter clockwise and remove.

2. Connect the adaptor to the hose and put the other end of the hose in the area where you are going to drain your

pool. (Check local regulations for drainage by-laws).

3. Screw control ring of the hose adaptor onto the drain valve clockwise. The drain valve will be open and water will

8. Air dry pool.

ATTENTION: Do not leave the drained pool outside.

Storage

1. Please remove all the accessories and spare parts of the pool and store them clean and dry.

2. Once pool is completely dry, sprinkle with talcum powder to prevent pool from sticking together, fold pool carefully.

If pool is not completely dry, mould may result and will damage the pool liner.

3. Store liner and accessories in a dry place with a moderate temperature between 5ºC / 41ºF and 38ºC / 100ºF.

4. During rainy season, pool and accessories should be storaged as above instruction also.

5. Unproper draining of the pool might cause serious personal injury and/or damage to personal property.

Frequently Asked Questions

grass is removed from where the pool will sit as it will die and may cause odors / slime. Certain types of hardy grass

can grow through the liner as can aggressive bushes / plants by the side of the pool. Ensure adjacent vegetation is cut

back where necessary. Use of a ground cloth assists in protecting the base of the pool.

2. How will I know if my pool is set up on unleveled ground?

If your pool appears to be bulging on one side it is not set up on level ground. It is important that you empty your pool

and move the pool to a level site. If the pool is not on level ground it will place undue stress on the seams and could

result in the seams bursting which will cause flooding, property damage and potentially personal injury or death.

Fill your pool following the instructions in the owner’s manual carefully. This will ensure that you do not waste water

and the pool can be moved easily so that the ground can be leveled at an appropriate time and not after you have

completely filled it with water.

again once the temperature rises. Note: Every use of air compressor or high pressure pump for the inflation of the ring

is forbidden. Bestway inflatables will not be responsible for bursting of the ring due to the use of air compressor.

4. Can I have my pool filled by a water service?

We recommend using a garden hose under low pressure for filling your pool. If it is necessary to use a water delivery

service, it is best to fill the pool with one inch of water by hose and smooth wrinkles first. Use a water service that is able

to regulate the flow of water to prevent damage. Ensure you stop at each step as noted in the instruction manual to

ensure your pool is level. Bestway will not be held responsible for pools damaged or weakened by water delivery

services.

5. What is the maximum fill height of the pool?

Fill pool until water capacity is 80% up to the bottom of the inflated ring of the pool. Never attempt to fill your pool

the inside of the pool to wipe off any oils and algae. Cut a circle large enough to cover the hole and apply the patch

securely onto the side in the water. Cut a second patch and apply to the outside of the pool for extra strength. If the hole

is in the base of the pool use one patch only and weigh it down with a heavy object while it bonds. For a hole in the top

ring, inflate the ring to locate the hole, mark the hole so you can see it easily and apply the patch pressing down firmly.

Once it is applied deflate the ring slightly to take some of the pressure off the patch. If the ring is completely deflated and

the pool is empty put a heavy weight onto the patch to assist in bonding. If you have patched the pool when it is empty

we recommend you leave it at least 12 hours before filling.

7. Where can I buy filter cartridges and how often should I change them?

Filter cartridges to fit your filter pump should be available from the store where you purchased your pool. If not, most

mass retailers sell filter cartridges as an accessory. If you are unable to obtain replacements please call our toll-free

chemicals properly balanced. If maintained correctly the water should last a full summer season. Please contact your

local pool chemical supplier for detailed information regarding chemicals, they will be able to advise you how to best

maintain the cleanliness of your water.

9. Do I need to take my pool down for the winter?

Yes, Above-ground pools may collapse under the weight of ice and snow and the PVC walls will be damaged. We

recommend taking the pool down when temperatures fall below 8ºC / 45ºF. The pool should be stored indoors in a

moderate temperature between 5ºC / 41ºF and 38ºC / 100ºF. Please store away from chemicals and rodents and out of

the reach of children.

10. My pool is fading – why is that?

Excessive use of chemicals can cause the color of the inside of the liner to fade; this is similar to a swimsuit fading