Robomow RC302 [22/58] Main zone

If the passage is WIDER than 1.5m:

If the Narrow Pass is wider than 1.5m (5 ft.), and you want Robomow to mow the area inside the Narrow Pass, then

you can set the wire as shown in the gure below. Such a setup allows the mower to mow inside the Narrow Pass

while mowing the inner part of the lawn, but prevents it from crossing between the zones.

1. Dene the entry to the Narrow Pass - the point you want the mower to start driving towards the Sub-Zone.

2. Set an Perimeter Island at the middle of the Narrow Pass (refer to 4.3.2) as shown in the picture above and

keep a distance of 10 cm (4 inches) from the Perimeter Wire.

3. The island dimensions should be 28 cm (11”) along the side and as wide as needed, when keeping 10 cm (4

inches) from both sides.

4. After completing the setup of the wire in the Sub-Zone, make sure you keep 10 cm (4 inches) between the wire

and the island on the way back to the Main Zone.

10cm

Sub-Zone

28cm

Min. 50cm

2 Wires under

same peg

10cm

Main-Zone

Good VS Bad Narrow Pass:

The following drawing illustrates a good (at) vs bad (bumpy) narrow passage.

Sub Zone

Main Zone

Sub Zone