Robomow RC302 [31/58] No wire signa
![Robomow TC150 [31/58] No wire signa](/views2/1172599/page31/bg1f.png)
30
5.2.3 Set Day and Time
• Scroll to set the Day and press OK to conrm.
• Scroll to set the Time and press OK to conrm.
5.2.4 Main Zone Area
• Scroll to select an approximate area (EU- m² / US- ft²) for the Main Zone,
where the Base Station is installed.
If an additional zone (Sub-Zone or Separated Zone) exists, do not include it in
main zone’s area (it will be set separately).
Note – It is necessary to complete the above settings (5.2.2 – 5.2.3) in order to operate the mower. Every
press on the STOP button will change the screen one step back in the process.
5.2.5 Test Base Station
Position
• After setting the area, U001 (Test Base Station Position) is
displayed.
• Place Robomow inside the lawn, approximately 3 m (10 ft.) in
front of the Base Station, facing the Perimeter Wire and press
OK to start the test.
• Robomow drives towards the Base Station:
If the mower does not start the test, then one of
the following messages will be displayed:
E3 (
No Wire Signal
)
– Conrm that the Power
Box is connected to the power outlet and that
the Extension Cable is connected at both ends,
from the Power Box to the Base Station.
U029 (
Swap wires in plot connector
)
– The
Perimeter Wire has been connected in the
opposite direction. Swap the wires at the plot
connector.
• Robomow will enter the Base Station, drive back, wait in front of
the Base Station, and display
U002
(
Peg Base).
If
U051
(Reposion Base Staon)
message is
displayed:
• Move the Base Station slightly to align it with
the Perimeter Wire.
• Check for any obstacles that may interfere
with the mower’s entrance to the Base
Station.
• While ‘U002’ (Peg Base) is displayed, insert the remaining Stakes
of the Base Station to secure it to the ground and press OK.
Содержание
- Operation and safety manual 2
- Table of contents 3
- Chapter 1 4
- Important 4
- Introduction and safety 4
- 7 6 5 4 3 2 5
- Safety warnings precautions 5
- Warning decal definitions 5
- Robomow safety features 7
- Chapter 2 8
- Know your robomow 8
- What s in the box 8
- How robomow works for you 9
- Robomow features 10
- Chapter 3 11
- Lawn types what does your lawn look like 11
- Planning ahead 11
- Main sub zone with a narrow pass 12
- Main zone sub zone s type lawn 12
- Separated zone 12
- Separated zones type lawn 12
- A separated zone larger than 100 m² 1100 ft² 13
- A separated zone smaller than 100 m² 1100 ft² 13
- Base station location guidelines 13
- Select base station location 13
- Setups 13
- Types of separated zone 13
- At a corner 14
- External setup off the lawn perimeter 14
- Internal setup on the lawn perimeter 14
- Main zone 14
- Outside the lawn 14
- There are two types of external setup 14
- Objects inside 15
- Planning the perimeter wire layout 15
- Select power box location 15
- Slopes 15
- Distances from the edge pools ponds cliffs etc 16
- Interference with adjacent lawns 16
- Chapter 4 17
- Initial setup 17
- Perimeter wire setup 17
- Preparations 17
- Laying the perimeter wire 18
- Starting point perimeter wire at the base station area 18
- Important information 19
- Min 1 m 4ft 19
- Perimeter wire within the working area 20
- Main zone 21
- Min 50cm 21
- Sub zone 21
- Main zone 22
- Min 50cm 22
- Sub zone 22
- Fastening perimeter wire to the 23
- Ground 23
- Main zone 23
- Back at the base station completing the perimeter wire setup 24
- Connecting the power box 25
- Laying and fastening extension cable 25
- Placement and connection of the base station 25
- At the power box location 26
- Determining the perimeter switch location 27
- Laying out the perimeter wire 27
- Perimeter switch placing options 27
- Setup in a non base zone 27
- At the perimeter switch s location 28
- Chapter 5 30
- Preparing robomow 30
- No wire signa 31
- Peg bas 31
- Position 31
- Reposition base station 31
- Swap wires in plot connecto 31
- Area setting indicator 33
- Automatic operation 33
- Battery and charging indicator 33
- Chapter 6 33
- Day and time setting indicator 33
- Days of the week 33
- Inactive time setting indicator rain sensor 33
- Mower is in the base station indicator 33
- Mowing hours setting indicator 33
- Operating panel 33
- Red lit constantly low battery green blinking charging green lit constantly fully charged 33
- Robomow operation 33
- User error messages 33
- Chapter 6 34
- Robomow operation 34
- Basic settings 35
- Menu options 35
- Screen setting description options 36
- Screen setting description options 37
- Screen setting description options 38
- Screen setting description options 39
- Operation in a non base zone using a perimeter switch 40
- Robomow app settings 40
- Chapter 7 41
- Enable disable the automatic operation 41
- Event description 41
- Power box alerts 41
- Turn the buzzer on off 41
- Using the power box 41
- Chapter 8 42
- Charging 42
- Chapter 9 43
- General error codes 43
- Robomow error codes table 43
- Troubleshooting and user messages 43
- Display message probable cause event corrective actions 44
- Detailed error codes 45
- Display message probable cause event corrective actions 45
- Display message probable cause event corrective actions 46
- Display message description required action 47
- User messages 47
- Basic troubleshooting 48
- Display message description required action 48
- Problem encountered probable cause event corrective actions 48
- U090 u093 48
- Problem encountered probable cause event corrective actions 49
- Code description corrective action 50
- Description of no depart codes 50
- Anti theft disabling device pin code write down your 4 digit anti theft disabling device pin code refer here if you ever forget the code 51
- Chapter 10 51
- Product specification 51
- Rc304 rc308 rc312 51
- Robomow serial number 51
- _______________________ 51
- Chapter 11 52
- Maintenance and storage 52
- Maintenance of the blade 53
- Lightning storm 54
- Maintenance of the base station area 54
- Splicing the perimeter wire 54
- Accessories 55
- Chapter 12 55
- Chapter 13 56
- Robomow lawn care has never been so easy 56
- Tips for maintaining your lawn 56
- Always follow the safety instructions specified in this user manual 57
- C series limited warranty 57
- Warranty card 57
Похожие устройства
- Robomow RC302 Инструкция QuickStart
- Lenovo b5030, 59-430205 Инструкция по эксплуатации
- Robomow RC306 Инструкция по эксплуатации
- Robomow RC306 Инструкция QuickStart
- Lenovo b5030, 59-430218 Инструкция по эксплуатации
- Lenovo b5030, 59-430217 Инструкция по эксплуатации
- Robomow RL555 Инструкция по эксплуатации
- Robomow RL555 Инструкция QuickStart
- Lenovo b5030, 59-430203 Инструкция по эксплуатации
- Lenovo b5070, 59-435371 Инструкция по эксплуатации
- Robomow RL855 Инструкция по эксплуатации
- Lenovo b5070, 59-435821 Инструкция по эксплуатации
- Robomow RL855 Инструкция QuickStart
- Lenovo b5070, 59-435373 Инструкция по эксплуатации
- Lenovo b5070, 59-435372 Инструкция по эксплуатации
- Lenovo g5030, 80g0016nrk Инструкция по эксплуатации
- Lenovo g5030, 80g000xwrk Инструкция по эксплуатации
- Lenovo ideapad s2030, 59-436224 Инструкция по эксплуатации
- Lenovo ideapad s2030, 59-436222 Инструкция по эксплуатации
- Lenovo thinkpad x240, 20al00dmrt Инструкция по эксплуатации
Скачать
Случайные обсуждения