![Robomow RC302 [45/58] Detailed error codes](/img/pdf.png)
Robomow RC302 [45/58] Detailed error codes
![Robomow MC500 [45/58] Detailed error codes](/views2/1172599/page45/bg2d.png)
44
Display Message Probable Cause/Event Correcve Acons
E8
Decrease
Inactive Time
- Too many Inactive Days and/or
Hours have been set for your lawn
area. Current settings will not be
changed.
- Mowing Frequency is too high for
current settings of Inactive Time.
The Inactive Time settings will be
set to defaults.
- Area setting is too high for current
settings of Inactive Time. The
Inactive Time settings will be set to
defaults.
- Decrease the number of Inactive Days and/
or the number of Inactive Hours to allow
Robomow to complete mowing your lawn.
- Decrease Mowing Frequency (see p001 in
the table in Section 6.4.2)
- Decrease Area setting
E9
See
Troubleshooting
in Manual
- E 9 is displayed for all other
messages that are not listed in the
above table.
- Press the ‘Right arrow’ button to receive the
stop reason number and refer to the next
table for more details about the stop reason,
causes, and actions.
9.2 Detailed Error Codes
If the above table (Section 9.1) does not give enough information to help solve the problem, then press the LEFT
arrow while the Error Code is displayed in order to receive a detailed error code for the problem and refer to the
table below:
Display Message Probable Cause/Event Correcve Acons
0010
Mow Overheat
- The mowing motor has been
working under a severe load for too
long.
- No need for action – Robomow will renew
automatically the operation after the mowing
motor will cool down.
0011
Drive Overheat
- The drive motors have been working
under a severe load for too long.
- No need to do anything.
- Robomow will renew the operation
automatically as soon as the drive motor will
cool down.
0012
No wire signal - See E3 in the above table
0014
Front wheel
problem
- See E7 in the above table
0015
Button pressed
- One of the operating panel buttons
is constantly pressed.
- Press ‘OK’ to conrm the message and
continue operation. This message is displayed
to inform only.
0016
Low
temperature
- Mower does not depart
automatically from the Base Station
when the ambient temperature is
lower than 5ºC (41ºF).
- Information - When the temperature
is below 5ºC (41ºF) the grass does
not grow or grows very slowly.
However Manual Depart is enabled.
- No need to do anything.
- Robomow will renew the operation
automatically as soon as the ambiance
temperature will rise above 5ºC (41ºF).
0020
Rain detected
- The operation is delayed as
Robomow detects rain.
- Robomow should resume operation
30 minutes after it stops to detect
the rain.
- No need for action.
- The message is displayed until Robomow will
not detect rain and then will start mowing.
0021
Check mowing
height
- Mowing motor has faced over-
current conditionsfor too long as a
result of high grass or an obstacle
that is stuck or wrapped around the
blade.
- Something is preventing the blade
from rotating freely.
- Severe grass accumulation under
the mowing deck, rope, or similar
object is wrapped around mowing
blade.
- CAUTION – Switch Off the Safety Switch
before checking the blade.
- Inspect the blade for foreign material or debris
preventing rotation.
- Clean out accumulated grass clippings using
a wooden stick.
Содержание
- Operation and safety manual 2
- Table of contents 3
- Chapter 1 4
- Important 4
- Introduction and safety 4
- 7 6 5 4 3 2 5
- Safety warnings precautions 5
- Warning decal definitions 5
- Robomow safety features 7
- Chapter 2 8
- Know your robomow 8
- What s in the box 8
- How robomow works for you 9
- Robomow features 10
- Chapter 3 11
- Lawn types what does your lawn look like 11
- Planning ahead 11
- Main sub zone with a narrow pass 12
- Main zone sub zone s type lawn 12
- Separated zone 12
- Separated zones type lawn 12
- A separated zone larger than 100 m² 1100 ft² 13
- A separated zone smaller than 100 m² 1100 ft² 13
- Base station location guidelines 13
- Select base station location 13
- Setups 13
- Types of separated zone 13
- At a corner 14
- External setup off the lawn perimeter 14
- Internal setup on the lawn perimeter 14
- Main zone 14
- Outside the lawn 14
- There are two types of external setup 14
- Objects inside 15
- Planning the perimeter wire layout 15
- Select power box location 15
- Slopes 15
- Distances from the edge pools ponds cliffs etc 16
- Interference with adjacent lawns 16
- Chapter 4 17
- Initial setup 17
- Perimeter wire setup 17
- Preparations 17
- Laying the perimeter wire 18
- Starting point perimeter wire at the base station area 18
- Important information 19
- Min 1 m 4ft 19
- Perimeter wire within the working area 20
- Main zone 21
- Min 50cm 21
- Sub zone 21
- Main zone 22
- Min 50cm 22
- Sub zone 22
- Fastening perimeter wire to the 23
- Ground 23
- Main zone 23
- Back at the base station completing the perimeter wire setup 24
- Connecting the power box 25
- Laying and fastening extension cable 25
- Placement and connection of the base station 25
- At the power box location 26
- Determining the perimeter switch location 27
- Laying out the perimeter wire 27
- Perimeter switch placing options 27
- Setup in a non base zone 27
- At the perimeter switch s location 28
- Chapter 5 30
- Preparing robomow 30
- No wire signa 31
- Peg bas 31
- Position 31
- Reposition base station 31
- Swap wires in plot connecto 31
- Area setting indicator 33
- Automatic operation 33
- Battery and charging indicator 33
- Chapter 6 33
- Day and time setting indicator 33
- Days of the week 33
- Inactive time setting indicator rain sensor 33
- Mower is in the base station indicator 33
- Mowing hours setting indicator 33
- Operating panel 33
- Red lit constantly low battery green blinking charging green lit constantly fully charged 33
- Robomow operation 33
- User error messages 33
- Chapter 6 34
- Robomow operation 34
- Basic settings 35
- Menu options 35
- Screen setting description options 36
- Screen setting description options 37
- Screen setting description options 38
- Screen setting description options 39
- Operation in a non base zone using a perimeter switch 40
- Robomow app settings 40
- Chapter 7 41
- Enable disable the automatic operation 41
- Event description 41
- Power box alerts 41
- Turn the buzzer on off 41
- Using the power box 41
- Chapter 8 42
- Charging 42
- Chapter 9 43
- General error codes 43
- Robomow error codes table 43
- Troubleshooting and user messages 43
- Display message probable cause event corrective actions 44
- Detailed error codes 45
- Display message probable cause event corrective actions 45
- Display message probable cause event corrective actions 46
- Display message description required action 47
- User messages 47
- Basic troubleshooting 48
- Display message description required action 48
- Problem encountered probable cause event corrective actions 48
- U090 u093 48
- Problem encountered probable cause event corrective actions 49
- Code description corrective action 50
- Description of no depart codes 50
- Anti theft disabling device pin code write down your 4 digit anti theft disabling device pin code refer here if you ever forget the code 51
- Chapter 10 51
- Product specification 51
- Rc304 rc308 rc312 51
- Robomow serial number 51
- _______________________ 51
- Chapter 11 52
- Maintenance and storage 52
- Maintenance of the blade 53
- Lightning storm 54
- Maintenance of the base station area 54
- Splicing the perimeter wire 54
- Accessories 55
- Chapter 12 55
- Chapter 13 56
- Robomow lawn care has never been so easy 56
- Tips for maintaining your lawn 56
- Always follow the safety instructions specified in this user manual 57
- C series limited warranty 57
- Warranty card 57
Похожие устройства
- Robomow RC302 Инструкция QuickStart
- Lenovo b5030, 59-430205 Инструкция по эксплуатации
- Robomow RC306 Инструкция по эксплуатации
- Robomow RC306 Инструкция QuickStart
- Lenovo b5030, 59-430218 Инструкция по эксплуатации
- Lenovo b5030, 59-430217 Инструкция по эксплуатации
- Robomow RL555 Инструкция по эксплуатации
- Robomow RL555 Инструкция QuickStart
- Lenovo b5030, 59-430203 Инструкция по эксплуатации
- Lenovo b5070, 59-435371 Инструкция по эксплуатации
- Robomow RL855 Инструкция по эксплуатации
- Lenovo b5070, 59-435821 Инструкция по эксплуатации
- Robomow RL855 Инструкция QuickStart
- Lenovo b5070, 59-435373 Инструкция по эксплуатации
- Lenovo b5070, 59-435372 Инструкция по эксплуатации
- Lenovo g5030, 80g0016nrk Инструкция по эксплуатации
- Lenovo g5030, 80g000xwrk Инструкция по эксплуатации
- Lenovo ideapad s2030, 59-436224 Инструкция по эксплуатации
- Lenovo ideapad s2030, 59-436222 Инструкция по эксплуатации
- Lenovo thinkpad x240, 20al00dmrt Инструкция по эксплуатации
Скачать
Случайные обсуждения