![Robomow RC302 [48/58] Basic troubleshooting](/img/pdf.png)
Robomow RC302 [48/58] Basic troubleshooting
![Robomow RC302 [48/58] Basic troubleshooting](/views2/1172599/page48/bg30.png)
47
EN
Display Message / Descripon Required Acon
U089
Child Lock feature is activated.
The operational buttons are locked to prevent
unintended operation, especially by children.
To operate the mower, rst press one of the
operating mode buttons and then to press the
OK button to conrm.
U090-
U093
Sub-Zone 1/2/3/4 entry problem.
The mower eitherfails to leave/bypassthe Base
Station on its way to the Sub-Zone,orfails to enter
the Sub-Zone.
The mower will try to reach the Sub-Zone every
two hours. If the mower fails to reach the Sub-
Zone within threeattempts, it will stay in the Base
Station until the end of current mowing cycle.
The mower will not skip to the next Sub-Zone (if
there are any), if it fails to reach the current one.
Try to startmanual mowing (refer to section
6.3 – Manual Operation). Check if something
disturbs mower’s driving backwards and/or
bypassing the Base Station. Conrm the mower
drives along the perimeter wire and doesn’t fall
off the lawn’s edge, when it departs from the
Base Station.
Conrm that the mower is able to follow the
perimeter wire along the narrow pass untilit
reaches the Sub-Zone. Refer to section 4.3.3
for instructions on how to set a narrow pass
properly.
U094
Raise mowing height when activating the
TurboMow mode.
Refer to sections 5.1 and P026 in Section 6.4.2
in the User Manual.
9.4 Basic Troubleshoong
The next table will give details and possible causes of other faults, which do not provide error codes. If a fault
cannot be dealt with using these tables, please call your service provider.
Problem
Encountered
Probable Cause/Event Correcve Acons
Poor quality of
mowing
- Dull blade - Replace blade.
- The grass is too high in relation to the set
cutting height.
- It is recommended to cut less than a 1/3 of the
green part of the grass.
- Set the cutting height to a higher position and
then successively lower.
- If it is during a fast growing season – change
the Mowing Frequency (refer to Section 6.4.2 –
P001).
- The grass is wet and causes
accumulation of grass clippings around
the blade.
- For best cut, operate Robomow when the grass
is dry. Do no to mow in the early morning hours.
- Switch Off the Safety Switch and use heavy
gloves to clean and remove the grass clippings.
Mower doesn’t
nd the Base
Station
- There is a Perimeter Island or a Narrow
Passage that prevents the mower to
complete its drive towards the Base
Station in Near Wire Follow mode.
- Reduce the Near Wire Follow Distance in the
Settings menu from the default 7.
Mower doesn’t
depart from the
Base Station for
a long time
- There are several possible reasons for a
non-departure, including inactive times,
rain detection, etc.
- Press and hold ‘Home’ button for 1 second
while the mower is in the Base Station. The
non-depart reason code will be displayed for
3 seconds. Refer to Section 9.4.1 for detailed
description of no-depart codes.
Robomow
is noisy and
vibrates
- Damaged or unbalanced blade
- Check if the lawn is free from branches, stones
or other objects that can damage the blade.
- Replace the blade
Mower does not
dock properly
and sometimes
misses the Base
Station contacts
- Height differences between the lawn and
the Base Station surface.
- Fill some ground to atten the lawn to the Base
Station to allow smooth entrance.
- The wire underneath the Base Station is
not tight and placed in the middle of the
Station.
- Conrm the wire underneath the Base Station
is straight, tight, and centered below the Base
Station.
- The Base Station is set up on a side
slope.
- Move the Base Station to a relatively level
ground.
- The Base Station is placed too close to
the corner of the lawn
- Move the Base Station so it is not within 3
meters after a corner.
Содержание
- Operation and safety manual 2
- Table of contents 3
- Chapter 1 4
- Important 4
- Introduction and safety 4
- 7 6 5 4 3 2 5
- Safety warnings precautions 5
- Warning decal definitions 5
- Robomow safety features 7
- Chapter 2 8
- Know your robomow 8
- What s in the box 8
- How robomow works for you 9
- Robomow features 10
- Chapter 3 11
- Lawn types what does your lawn look like 11
- Planning ahead 11
- Main sub zone with a narrow pass 12
- Main zone sub zone s type lawn 12
- Separated zone 12
- Separated zones type lawn 12
- A separated zone larger than 100 m² 1100 ft² 13
- A separated zone smaller than 100 m² 1100 ft² 13
- Base station location guidelines 13
- Select base station location 13
- Setups 13
- Types of separated zone 13
- At a corner 14
- External setup off the lawn perimeter 14
- Internal setup on the lawn perimeter 14
- Main zone 14
- Outside the lawn 14
- There are two types of external setup 14
- Objects inside 15
- Planning the perimeter wire layout 15
- Select power box location 15
- Slopes 15
- Distances from the edge pools ponds cliffs etc 16
- Interference with adjacent lawns 16
- Chapter 4 17
- Initial setup 17
- Perimeter wire setup 17
- Preparations 17
- Laying the perimeter wire 18
- Starting point perimeter wire at the base station area 18
- Important information 19
- Min 1 m 4ft 19
- Perimeter wire within the working area 20
- Main zone 21
- Min 50cm 21
- Sub zone 21
- Main zone 22
- Min 50cm 22
- Sub zone 22
- Fastening perimeter wire to the 23
- Ground 23
- Main zone 23
- Back at the base station completing the perimeter wire setup 24
- Connecting the power box 25
- Laying and fastening extension cable 25
- Placement and connection of the base station 25
- At the power box location 26
- Determining the perimeter switch location 27
- Laying out the perimeter wire 27
- Perimeter switch placing options 27
- Setup in a non base zone 27
- At the perimeter switch s location 28
- Chapter 5 30
- Preparing robomow 30
- No wire signa 31
- Peg bas 31
- Position 31
- Reposition base station 31
- Swap wires in plot connecto 31
- Area setting indicator 33
- Automatic operation 33
- Battery and charging indicator 33
- Chapter 6 33
- Day and time setting indicator 33
- Days of the week 33
- Inactive time setting indicator rain sensor 33
- Mower is in the base station indicator 33
- Mowing hours setting indicator 33
- Operating panel 33
- Red lit constantly low battery green blinking charging green lit constantly fully charged 33
- Robomow operation 33
- User error messages 33
- Chapter 6 34
- Robomow operation 34
- Basic settings 35
- Menu options 35
- Screen setting description options 36
- Screen setting description options 37
- Screen setting description options 38
- Screen setting description options 39
- Operation in a non base zone using a perimeter switch 40
- Robomow app settings 40
- Chapter 7 41
- Enable disable the automatic operation 41
- Event description 41
- Power box alerts 41
- Turn the buzzer on off 41
- Using the power box 41
- Chapter 8 42
- Charging 42
- Chapter 9 43
- General error codes 43
- Robomow error codes table 43
- Troubleshooting and user messages 43
- Display message probable cause event corrective actions 44
- Detailed error codes 45
- Display message probable cause event corrective actions 45
- Display message probable cause event corrective actions 46
- Display message description required action 47
- User messages 47
- Basic troubleshooting 48
- Display message description required action 48
- Problem encountered probable cause event corrective actions 48
- U090 u093 48
- Problem encountered probable cause event corrective actions 49
- Code description corrective action 50
- Description of no depart codes 50
- Anti theft disabling device pin code write down your 4 digit anti theft disabling device pin code refer here if you ever forget the code 51
- Chapter 10 51
- Product specification 51
- Rc304 rc308 rc312 51
- Robomow serial number 51
- _______________________ 51
- Chapter 11 52
- Maintenance and storage 52
- Maintenance of the blade 53
- Lightning storm 54
- Maintenance of the base station area 54
- Splicing the perimeter wire 54
- Accessories 55
- Chapter 12 55
- Chapter 13 56
- Robomow lawn care has never been so easy 56
- Tips for maintaining your lawn 56
- Always follow the safety instructions specified in this user manual 57
- C series limited warranty 57
- Warranty card 57
Похожие устройства
- Robomow RC302 Инструкция QuickStart
- Lenovo b5030, 59-430205 Инструкция по эксплуатации
- Robomow RC306 Инструкция по эксплуатации
- Robomow RC306 Инструкция QuickStart
- Lenovo b5030, 59-430218 Инструкция по эксплуатации
- Lenovo b5030, 59-430217 Инструкция по эксплуатации
- Robomow RL555 Инструкция по эксплуатации
- Robomow RL555 Инструкция QuickStart
- Lenovo b5030, 59-430203 Инструкция по эксплуатации
- Lenovo b5070, 59-435371 Инструкция по эксплуатации
- Robomow RL855 Инструкция по эксплуатации
- Lenovo b5070, 59-435821 Инструкция по эксплуатации
- Robomow RL855 Инструкция QuickStart
- Lenovo b5070, 59-435373 Инструкция по эксплуатации
- Lenovo b5070, 59-435372 Инструкция по эксплуатации
- Lenovo g5030, 80g0016nrk Инструкция по эксплуатации
- Lenovo g5030, 80g000xwrk Инструкция по эксплуатации
- Lenovo ideapad s2030, 59-436224 Инструкция по эксплуатации
- Lenovo ideapad s2030, 59-436222 Инструкция по эксплуатации
- Lenovo thinkpad x240, 20al00dmrt Инструкция по эксплуатации
Скачать
Случайные обсуждения