Moxa EDS-P308-S-SC [9/16] Din rail mounting

- 9 -

DIN-Rail Mounting

The aluminum DIN-Rail attachment plate should already be fixed to the

back panel of the EDS-P308 Series when you take it out of the box. If you

need to reattach the DIN-Rail attachment plate, make sure the stiff metal

spring is situated towards the top, as shown in the figures below.

STEP 1:

Insert the top of the DIN

-Rail into

the slot just below

the stiff metal spring.

STEP 2:

The DIN

-Rail attachment unit will

snap into place as shown below.

To remove the Moxa EtherDevice Switch from the DIN-Rail, simply

reverse Steps 1 and 2 above.

Wall Mounting (optional)

For some applications, you will find it convenient to mount EDS-P308

Series on the wall, as illustrated below.

STEP 1:

Remove the aluminum

DIN

-Rail attachment plate

from the EDS

-P308’s rear

panel, and then attach the

wall mount plates, as shown

in the diagram below.

STEP 2: Mounting the EDS-P308 on the wall requires 4

screws. Use the switch, with wall mount plates

attached, as a guide to mark the correct locations of the

4 screws. The heads of the screws should be less than

6.0 mm in diameter, and the shafts should be less than

3.5 mm in diameter, as shown in the figure at the right.

NOTE

Before tightening the screws into the wall, make sure the screw

head and shank size are suitable by inserting the screw into one

of the keyhole-shaped apertures of the wall mounting plates.

Do not screw the screws in all the way—leave about 2 mm to allow room

for sliding the wall mount panel between the wall and the screws.