Moxa TC-6110-T-LX [18/46] Attention

TC-6110 Series Hardware Hardware Installation

2-8

For the TC-6110 computers used in the field site, follow these steps to connect the power:

Step 1: Connect the ends of the extended power switch cable to the male portion of the 2-pin Euroblock

(provided); you may also choose to not use the cable extender, and connect the switch to the terminal directly.

Step 2: Plug the male Euroblock into the matching female terminal on the front panel.

Step 3: Make sure the power switch is turned off (Open).

Step 4: Connect the earthing/ground cable to the ground connector (Phillips head) on the lower right corner of

the front panel.

Step 5:

Connect the M12 connector to the power cable’s output end using the pin

assignment at right.

Step 6:

Connect this M12 connector to power input 1 on the front panel of the

computer.

Step 7: Use the same method to prepare a cable for power input 2.

Step 8: Turn on the computer. If the power supply is connected properly, the Power and System Power LEDs

will be on, and the yellow Ready LED will also be on. If you need to disconnect the power, reverse these steps.

ATTENTION

Please note that the branch circuit over current protection must be rated maximum 10 A.