Moxa ioLogik E1210 — настройка Peer-to-Peer сетей для удаленной автоматизации [47/115]

Превью страниц Страница 47 / 115

ioLogik E1200 Series Using the Web Console

3-18

Peer-to-Peer Networking

In some remote automation implementations, the control room and field sensors may be spread far apart from

each other, often with only a single remote I/O module to collect data from all the sensors. Peer-to-peer

communication has little or no limitation as it replaces cable by integrating multiple I/O signals over a single

network cable to transmit input-to-output controls without the aid of PLCs or controllers. Featuring

peer-to-peer communications and support for channel-to-channel mapping, the ioLogik E1200 allows

simultaneous multiple target transmissions. In addition, the ioLogik E1200 supports up to 16 channels for

transmission over Ethernet (based on an emitter and receiver I/O pair).

Peer-to-Peer Settings (1-50)

The ioLogik E1200 supports up to 50 peer-to-peer mapping rules. You can configure the channel settings 10 at

a time. To enable the rules, either select the Enable All box to enable all 10 channels, or select the Enable box

individually for each rule. The Local Channel dropdown menu allows you to specify the channel of the ioLogik

E1200 to configure. Type the IP address and port number of a remote ioLogik E1200 in the Remote IP and

Remote Ports fields, respectively. The Remote Channel field is for you to select input channels of the remote

ioLogik E1200 when you select output channels in the Local Channel field. Set the Interval Time and On

change percentage on the local ioLogik E1200 that will trigger the transmission of a mapping signal to the

remote ioLogik E1200. The default local listen port number is 9020; this value can be set from 1 to 65535.

NOTE

If you select a DI or AI channel in the Local Channel field, the Remote Channel field will be disabled. You need

to configure the

DO or AO channel on the remote ioLogik E1200.