Moxa MxNVR-MO4 [11/61] Reset button

Moxa MxNVR-IA8 Introduction

1-7

Reset Button

A recessed RESET button is provided for rebooting and restoring the system to the factory default settings. Use

a pointed object, such as a straightened paper clip or toothpick, to press the reset button.

Reboot:

To reboot the MxNVR-IA8, power it off and then power it back on again, or push the RESET button one time.

The STAT LED will light in red as the POST (Power On Self Test) process runs. When the rebooting process is

finished, the STAT LED will turn green.

Restore to Factory Settings:

A recessed RESET button is provided for restoring the system to the factory default settings. When the system

fails to install properly, or operates abnormally, use the RESET button located on the front panel of the

MxNVR-IA8 to restore the factory defaults.

To do this, use a pointed object such as a straightened paper clip or toothpick to hold down the reset button,

and then release the reset button when the STAT LED stops flashing in red. At this point, the POST process will

run, and the MxNVR-IA8 will reboot. The STAT LED will turn green when the MxNVR-IA8 has finished rebooting.

2.5-inch Hard Disk Sockets (HDD1 and HDD2)

The MxNVR-IA8 has two built in 2.5-inch hard disk sockets with SATA connectors to connect with 2.5-inch SATA

hard disks or 2.5-inch SSDs (solid state disks). These 2 hard disk sockets are located on the front panel of

MxNVR-IA8. You will need to buy 2.5-inch hard disks for the MxNVR-IA8 (0 to 60°C) and 2.5-inch SSDs (solid

state disks) with -40 to 75°C operating temperature for the MxNVR-IA8-T.

NOTE There are a lot of hard disk suppliers on the market. We recommend using the main supplier’s products with

the

MxNVR-IA8. The MxNVR-IA8 was tested in our lab using a 2.5” Toshiba MK5065GSX (500GB) HDD, and the

MxNVR-IA8-T was tested in our lab with an Innodisk SATA 10000 (128 GB) SSD.

NOTE The MxNVR-IA8 comes with a 5-year warranty, but this warranty policy does not include the 2.5-inch SATA

HDD and SSD, which are covered by the original manufacturers warranty.

NOTE To install the 2.5-inch SATA HDD or SDD, refer to the HDD installation section in Chapter 2.