Gorenje SGT2400BW Инструкция по эксплуатации онлайн [41/104] 19401

Gorenje SGT2400BW Инструкция по эксплуатации онлайн [41/104] 19401
41
Water droplets come
out of the soleplate.
When you start steam ironing and when you continue steam ironing
after an interruption, the steam that was still present in the supply hose
has cooled down and condensed into water. This causes water droplets
to come out of the soleplate. This happens sometimes when you start
ironing or continue ironing after an interruption. Hold the iron over an
old cloth and press the steam trigger. Wait until steam instead of water
comes out of the soleplate.
The set temperature is too low for steam ironing. Set a temperature of
2 or higher.
The wet spots that appear on your garment after you have steam ironed
for some time may be caused by steam that has condensed onto the
ironing board. Iron the wet spots without steam for some time to dry
them. If the underside of the ironing board is wet, wipe it dry with a
piece of dry cloth.
Steam may have condensed in the hose, the temperature may have
been set below 3 or the appliance may not be ready for steam ironing.
Flakes and impurities
come out of the
soleplate or the
soleplate is dirty.
Impurities or chemicals present in the water have deposited in the
steam vents and/or on the soleplate. Clean the soleplate with a damp
cloth.
The appliance produces a
pumping sound.
Water is pumped into the boiler inside the steam generator. This is
normal. However, if the pumping sound does not stop, switch off the
appliance immediately and unplug it. Contact an authorised Gorenje
service centre.
Water leaks out of the
steam generator.
The Anti Calc tank has overflowed during the Auto Anti Calc process.
Always empty the Anti Calc tank after the Anti Calc process. This
prevents the Anti Calc tank from overflowing the next time the auto
Anti Calc process is performed.
The appliance
occasionally produces
a loud pumping noise
and clicking sound.
This happens during the Auto Anti Calc process. Water is pumped
from the water tank into the steam generator, and expelled into the Anti
Calc tank. Wait a few minutes for the appliance to complete the Auto
Anti Calc process. Empty the Anti Calc tank and then top up the
water tank. The Auto Anti Calc process is a normal process that is
performed automatically at regular intervals.
I cannot place the iron
on its heel.
To make the appliance more ergonomic, it has been designed in such a
way that the iron can only be put down horizontally. Place the iron
horizontally on the heat-resistant iron resting mat. The mat can be left
on top of the steam generator or you can place the mat on the ironing
board. Do not place the hot iron directly onto the ironing board without
the heat-resistant iron resting mat.
The appliance beeps
continuously.
The water tank has gone empty during the Auto Anti Calc process. Fill
the water tank.
The Anti Calc tank
light flashes.
The Auto Calc Clean process is completed. Empty the Anti Calc tank.
Do not unplug the appliance when you do this.

Содержание

Скачать
Случайные обсуждения