Makita em3400u — как проверить и обслуживать свечи зажигания и топливный фильтр [19/212]

Превью страниц Страница 19 / 212

(1)

(2)

0.6 mm - 0.7 mm

(0.024” - 0.028”)

CHECKING THE SPARK PLUG

– Only use the supplied universal wrench to remove or to install the spark plug.

– The gap between the two electrodes of the spark plug should be 0.6 - 0.7 mm

(0.024” - 0.028”). If the gap is too wide or too narrow, adjust it. If the spark

plug is clogged or contaminated, clean it thoroughly or replace it.

Place the plug cap properly as illustrated after checking.

CAUTION: Never touch the spark plug connector while the engine is running

(danger of high voltage electric shock).

SUPPLY OF GREASE TO GEAR CASE

– Supply grease (Shell Alvania 2 or equivalent) to the gear case (1) through the

grease hole (2) every 30 hours. (Genuine MAKITA grease may be purchased

from your MAKITA dealer.)

CLEANING OF FUEL FILTER

WARNING: INFLAMMABLES STRICTLY PROHIBITED

Interval of inspection: Monthly (every 50 operating hours)

Suction head in the fuel tank

&KHFNWKHIXHO¿OWHUSHULRGLFDOO\7RFKHFNWKHIXHO¿OWHUIROORZWKHVWHSV

below:

1. Remove the fuel tank cap, drain the fuel to empty the tank. Check the tank

inside for any foreign materials. If any, remove them.

2. Pull out the suction head by using a wire hook through the tank opening.

 ,IWKHIXHO¿OWHUFORJJHGVOLJKWO\FOHDQLW7RFOHDQLWJHQWO\VKDNHDQGWDS

it in fuel. To avoid damage, do not squeeze or rub it. The fuel used for the

FOHDQLQJPXVWEHGLVSRVHGLQDFFRUGDQFHZLWKWKHPHWKRGVSHFL¿HGE\

regulations in your country.

 ,IWKHIXHO¿OWHUEHFDPHKDUGRUKHDYLO\FORJJHGXSUHSODFHLW

 $IWHUFKHFNLQJFOHDQLQJRUUHSODFLQJLQVHUWWKHIXHO¿OWHULQWRWKHIXHOSLSH

DQG¿[LWE\WKHKRVHFODPS3XVKWKHIXHO¿OWHULQDOOWKHZD\WRWKH

bottom of the fuel tank.

&ORJJHGRUGDPDJHGIXHO¿OWHUFDQFDXVHLQVXI¿FLHQWIXHOVXSSO\DQGUHGXFH

HQJLQHSRZHU5HSODFHWKHIXHO¿OWHUDWOHDVWTXDUWHUO\WRHQVXUHVDWLVIDFWRU\IXHO

supply to the carburetor.

(1)

(2)

(3)

(1)