GRAPHITE 59G806 Инструкция по эксплуатации онлайн [22/224] 320602

22

OPERATION OF THE TABLE EXTENSIONS

Ɣ The table extensions (16) are located on both sides of the mitre saw base.

Ɣ Unlock the locking knobs of the table extension (18) (g. C).

Ɣ Adjust the length of the table extensions.

Ɣ Fasten the table extension using the locking knobs (18).

Ɣ If needed, the tilting limiters can be used (17) to facilitate cutting to size.

OPERATION OF THE CUTTING DEPTH LIMITER

The cutting depth limiter can be used, when it is necessary to make a key in the workpiece. It is

Ɣ Lower the extension arm and hold it in the lower position leaning against the cutting depth limiter.

Ɣ Rotate (to the left or right) the cutting depth limiter bolt (11) (g. D) to obtain the required depth of the

cutting disc.

Ɣ Loosen the guide locking knob (12).

Ɣ Make the cuts to the set depth.

Ɣ In order to return to the full cutting depth, rotate the cutting depth limiter (10) to the position, in which

SETTING THE WORKING TABLE FOR MITRE CUTTING

The rotary extension arm allows for cutting the workpiece at any angle in the range of 45° left or right from the

Ɣ Lock the working table locking knob (23).

automatic setting of the rotary extension arm is made. This can be done only when the automatic setting

lever (22) is not held in the pressed position and it can be locked in factory-marked positions during the

for angle measurements.

CHECKING AND ADJUSTING THE PERPENDICULAR POSITION OF THE CUTTING DISC AND

table lock knob (23).

Ɣ Press the cutting disc guard lever (5) and lower the saw head to the extreme lower position.

Ɣ Use the tool to check perpendicularity of the cutting disc in relation to the working table.

When making measurements make sure that measurement instrument does not touch any cutting

disc tooth, otherwise the measurement may be inaccurate due to the thickness of the sintered

carbide insert.