Tp-Link TL-ER6120 Инструкция по эксплуатации онлайн [35/167] 39127

-30-

Note:

If the LAN IP address is changed, you must use the new IP address to log into the Router. To

guarantee a normal communication, be sure to set the Gateway address and the Subnet Mask of the

Hosts on the LAN to the new LAN IP address and the Subnet Mask of the Router.

3.1.4.2 DHCP

The Router with its DHCP (Dynamic Host Configuration Protocol) server enabled can automatically

assign an IP address to the computers in the local area network.

Choose the menu Network→LAN→DHCP to load the following page.

Figure 3-13 DHCP Settings

The following items are displayed on this screen:

¾ DHCP Settings

DHCP Server:

Enable or disable the DHCP server on your Router. To enable the

Router to assign the TCP/IP parameters to the computers in the LAN

automatically, please select Enable.

Start IP Address:

Enter the Start IP address to define a range for the DHCP server to

assign dynamic IP addresses. This address should be in the same IP

address subnet with the Router’s LAN IP address. The default

address is 192.168.0.2.

End IP Address:

Enter the End IP address to define a range for the DHCP server to

assign dynamic IP addresses. This address should be in the same IP

address subnet with the Router’s LAN IP address. The default

address is 192.168.0.254.