Tp-Link T1700X-16TS V3 [95/468] Loopback detection interface

Tp-Link T1700X-16TS V3 [95/468] Loopback detection interface
10.4 loopback-detection (interface)
Description
The loopback-detection command is used to enable the loopback
detection function of the specified port. To disable it, please use no
loopback-detection command.
Syntax
loopback-detection
no loopback-detection
Command Mode
Interface Configuration Mode (interface ten-gigabitEthernet | interface range
ten-gigabitEthernet | interface port-channel | interface range port-channel )
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Enable the loopback detection function of ports 1-3:
T1700X-16TS(config)# interface range ten-gigabitEthernet 1/0/1-3
T1700X-16TS(Config-if-range)# loopback-detection
10.5 loopback-detection config process-mode
Description
The loopback-detection config process-mode command is used to
configure the process-mode for the ports by which the switch copes with the
detected loops. You also need to configure the recovery mode to remove the
block status of the port or VLAN when the process-mode is Port Based or
VLAN Based.
Syntax
loopback-detection config process-mode { alert | port-based | vlan-based }
recovery-mode { auto | manual }
Parameter
alert
——
When a loop is detected, the switch will send a trap message and
generate an entry on the log file. It is the default setting
.
port-based
——
When a loop is detected, the switch will send a trap message
and generate an entry on the log file. In addition, the switch will block the port
74

Содержание

Похожие устройства

Скачать