Home
Главная
Thomas
Пылесосы
Super 30S Aquatherm
Инструкция по эксплуатации Страница: 14

Thomas Super 30S Aquatherm Инструкция по эксплуатации онлайн [14/48] 49688

Congratulations on your new

purchase!

Enjoy your appliance to the full through

correct usage.

Areas of application

• Scrubbing of hard floors with hot water.

• Spray-vacuuming for deep cleaning and stain

removal of carpeting, hard floors, and upholstery,

i.e. as wash-vacuum cleaner.

• Wet vacuuming, i.e. vacuuming water and other

spilt liquids.

• Vacuuming of carpeting, hard floors, upholstery,

etc. with all the benefits of modern floor vacuuming

technology.

Unpacking the appliance

Unpack the appliance from the carton, remove any

packaging and identify the following parts and

functions in the diagrams at the beginning of this

booklet to gain a better understanding of the

instructions given below.

Assembly instructions

The parts required for the chassis are to be found

loosely packed in the carton.

Assembling the castor wheels

Undo the snap-on fasteners (3) and lift off the

motor block (2).

Take out the extraction liquid tank (28) and

cleaning solution. Turn the collecting bin (1) upside

down, i.e. with the opening facing the floor.

C To facilitate assembly, we recommend lightly

greasing the pegs at both ends.

First insert the pegs (3) in the base of the collecting

bin (1), then push them in, together with the

castors, as far as they will go.

Turn the collecting bin (1) back over onto the

castors (4) and check that these have been

correctly assembled by moving the collecting bin

(1) back and forth in all directions.

Fitting the motor block

Place the motor block (2) on the collecting bin (1),

making sure that the surfaces of both parts

correspond. Secure the motor block (2) by means

of both snap-on fasteners (3).

Connecting the flexible hose

Insert the flexible hose (13) in the suction socket (8)

in such a manner that the markings on both the

suction socket and the hose connecting piece

correspond and the button clicks into place.

Remove the hose by turning the hose connecting

piece and slowly with drawing the hose.

Then attach the desired accessories.

Suction tube holder

The suction tubes (14) complete with accessories

and flexible hose (13) can be hooked into the

fixtures at the back of the appliance.

Cable storage

After use, the mains cable (1) can be wound

loosely in the hand and hung over the notch in the

carrying handle, as shown in the illustration.

Changing the filter

Always pull out the plug before changing

the filter!

NOTE!

Hygienic filter change and emptying of the

collector bin.

Emptying the collector bin and charge of all filter

typesused in the vacuum cleaner (e. g. foam-/paper

filters, paper filter bags, etc.) can be done hygienically.

To this end, please use the hygienic gloves included in

the delivery.

Replacement gloves are readly, available at relevant

supply stores.

Motor protection filter

After each wet suction and spray extraction

process, check the motor protection filter (33) for

contaminations and clean if required. For this,

open the float valve (38) in the direction of the

arrow, and take the motor protection filter from

the suction opening. Replace the cleaned or new

filter and then reassemble the float valve to the

motor block.

Paper filter bag

Place the filter bag (34) inside the collecting bin (1),

making sure that the opening located in the

cardboard inlay (35) is placed in line with the

suction socket (8).

Then press the filter bag (34) evenly around the

sides of the collecting bin (1).

THOMAS paper filter bags are essential when

vacuuming fine dust, e.g. soot, ashes, sawdust or

cement. However, they are also recommended for

normal use, as they not only improve the retention

of dust, but also make filter changes more

hygienic.

Thomas Super 30S Aquatherm Инструкция по эксплуатации онлайн [14/48] 49688

Содержание

Похожие устройства