Qtech QSW-8200-52T-AC [12/36] Debug ipv6 vrrp

User Manual

Chapter 2. Commands for IPv6 VRRPv3 Configuration 12

www.qtech.ru

 When this command is used, if the status of an interface monitored turns from up to

down, then the priority of that very router (or L3 Ethernet switch) in its Standby cluster

will decrease (If the priority of that value_reduced is higher than interface

configuration, then the corresponding router is down, the priority of interface in

Backup decrease until 0), lest Backup cannot changes its status due to lower priority

than the Master when the Master fails. After the interface monitored turns up over

again, the priority of corresponding router (or L3 Ethernet switch) will restore in

Backup.

 Example: Configuring VRRPv3 monitor interface to VLAN 2 and decreasing amount of

priority to 10.

 Switch(Config-router)# circuit-failover vlan 2 10

2.3 debug ipv6 vrrp

 Command: debug ipv6 vrrp [all | events | packet [recv | send]]

 no debug ipv6 vrrp [all | events | packet [recv | send]]

 Function: Display the state change, message receiving and sending of a VRRPv3 backup

group, the no operation of this command will disable the display of DEBUG.

 Parameters: None.

 Command Mode: Admin Mode.

 Example:

 Switch#debug ipv6 vrrp

 Jan 01 01:03:13 2006 NSM: VRRP6 SEND[Hello]: Advertisement sent for vrid=[1],

virtual-ip=[fe80::2]

 Jan 01 01:03:14 2006 NSM: VRRP6 SEND[Hello]: Advertisement sent for vrid=[1],

virtual-ip=[fe80::2]

 Jan 01 01:03:15 2006 NSM: VRRP6 SEND[Hello]: Advertisement sent for vrid=[1],

virtual-ip=[fe80::2]

2.4 disable

 Command: disable

 Function: Disable VRRPv3 virtual router.

 Parameters: None.

 Command Mode: VRRPv3 Protocol Mode.

 Default: There is no configuration by default.

 Usage Guide: Disable the corresponding virtual router session. Only after disabling the

virtual router, can the relative configuration parameters be changed.

 Examples: Disable the VRRPv3 virtual router whose ID is 10.